Electronics Forum | Mon Jun 15 05:09:47 EDT 2020 | compit
This is not calibrated - it is set with a screw. Send a model or photo.
Electronics Forum | Tue Dec 20 08:26:17 EST 2005 | geb
Thanks for the info. Yes the old camera was a 4mil rectangle, and the new one is a 1mil circle, 2 slots wider. The camera was calibrated on install, but they must have done something wrong, cos it doesn't realise it is 2 slots short. This screws up t
Electronics Forum | Tue Jul 26 03:43:28 EDT 2005 | Rob
Hi Grant, We used to use Quicher automatic screw feeders - that basically present the screw for pick up to the driver - they worked very well. Let me know if you want any further info on this type of feeder as they may still be kicking around her
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Fri Mar 20 01:04:20 EDT 2009 | padawanlinuxero
Guys I need help!!! Today I was cleaning the TM12 feeder and by accident I took out a screw that is on the side in a place that looks... well it looks like a teddy bear, I heard something falling inside of the feeder and now the screw does not thigh
Electronics Forum | Wed Jan 31 19:16:46 EST 2007 | mika
BTW GEB; When you put the feeder in the front bank did you pick the comps with Head #2 and from the feeder bank just opposite from the rear non working feeder bank? Did you make your feeder banks fixed or is it already that? It just hits me, if you
Electronics Forum | Wed Apr 09 15:05:45 EDT 2003 | russ
Probably of no help but here it is anyway This is a tuff one. Attrition is due to many factors. You have machine rejects (visual fail, no pick), feeder set-up loss each time a reel is removed you lose X number of parts depending on feeder design (w
Electronics Forum | Fri May 06 06:54:56 EDT 2022 | jojoled
I have JUKI KE760L, and did notice that, when In "Feeder data " I select feeder position say 20, it enters XYZ coordinates for "pick coordinates" for example X=-260, Y=-25, Z=-1, which I need to "correct always by camera (it is slightly shifted).....
Electronics Forum | Thu Jan 27 21:43:35 EST 2022 | williamaxler
Take the 2 screws out of the pitch plate and flip it over.
Electronics Forum | Thu Feb 05 08:27:58 EST 2004 | pjc
We had a V-Tek TM30 manual taping machine using heat seal top tape. Had very good results- with skilled operator - to supply taped components to our 2x Fuji IP2 machines - no tape cropping. Stefan's points are somewhat valid, but you can have a succe