Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Mon Dec 12 22:14:42 EST 2005 | davef
�a va Frank? Well, popularity depends on the beholder. Never heard of your "Specnor" machine. US and Eurolanders take different approaches to conveying boards. * US: Finger conveyors * Eurolanders: Pallet conveyors Suppliers of wave solder machin
Electronics Forum | Fri Jul 17 10:50:49 EDT 1998 | Rob
| Howdy, | Is anyone using Seho? Need to know more about 7000 series machines with nitrogen and ultrasonic fluxer capabilities. Any shortcomings (I can't see them)? What are the positives, beside those obvious? | Earl Moon I have a 7240n2-F. I have
Electronics Forum | Mon Sep 11 09:39:31 EDT 2000 | Chris May
Charlie, Check: a)That your wave is not too high/powerful as this will push up components due to force exerted by mass of solder b)That your conveyor is set at optimimu height so that a) is not required. If conveyor is too high, then the wave will
Electronics Forum | Mon Oct 16 16:01:42 EDT 2006 | timnop
I have a wave machine (offshore made) with internal spray fluxer configured with a conventional spray gun set up. In order to spray fluid (in this case, flux) I must set the air pressure at 0.3 mPA (43 PSI). At that pressure, my flux sprayer creates
Electronics Forum | Sun May 21 23:29:38 EDT 2017 | zsoden
Hi all, We run an old Seho 1135C wave solder with a 63/37 pot at 250°C. It has been running well for a couple of years but we have noticed lately that all of the larger pads (terminal blocks, transformers, etc.) require additional solder to be appli
Electronics Forum | Thu Oct 18 11:59:38 EDT 2012 | jackofallmasterofnone
1) At this time we do not have a design engineer. I have contacted the PCB manufacturer about changing the drill file to close up the diameter on the holes a bit. This should allow the wings on the leads of the component to rest on top of the holes i
1 |