Electronics Forum | Thu Jan 11 22:01:09 EST 2007 | davef
Joe: I know this is not the correct forum to post chip "reworking" questions. Reply: Rework questions are as appropriate as the next topic here on SMTnet J: BGA will not reflow at any normal temperature level. I believe these chips may have been gen
Electronics Forum | Sun Jan 14 12:42:35 EST 2007 | SMTRework
I think the main cause of this condition is #3 because both #1 and #2 never change from board to board, these are identical boards with identical BGA revisions. These BGA's (as stated before) are about 3 years old.. I don't believe they are lead free
Electronics Forum | Thu Jan 11 09:19:56 EST 2007 | SMTRework
I know this is not the correct forum to post chip "reworking" questions but you guys have been very helpful in the past. My question is this, when we rework BGA components most of the time the solder reflows at a normal temp and all is well. On occ
Electronics Forum | Thu Jan 11 16:01:52 EST 2007 | russ
You using lead free BGAS now? What is your rework equipment and process? I am sure we can help you out here with some more detail, you should get the package data sheets for your problem BGAs and determine ball alloy or they may even be CCGA packag
Electronics Forum | Sun Jan 14 12:48:53 EST 2007 | SMTRework
Also, I was beginning to think that the humidity level in the facility was a factor.. but I don't believe that's the case.. as this condition seems to occur regardless of the humidity level.. Equipment being used is as follows.. Metcal BGA 3500
Electronics Forum | Tue Apr 16 05:05:32 EDT 2013 | stivais
We recently had a discussion with customer's QM - he claims that calculations for a proper solder wire diameter and soldering iron tip size (and temperature) have to be performed and documented for all manual (T/H) solderings (based on component size
Electronics Forum | Tue Aug 22 14:59:55 EDT 2000 | Mike Naddra
What does the reflow profile look like , the question I had was surrounding the higher reflow temperature and the max temperature that lowest thermal mass components will see. Some other questions that I had were surrounding the components , what of
Electronics Forum | Tue Aug 22 16:02:07 EDT 2000 | Dr. Ning-Cheng Lee
If the thermal mass of the products is small, a tent-shaped profile is recommended, with peak temperature around 240C. The hottest spot on board should be less than 250C. However, if the thermal mass of the product is large, such as a large server PC
Electronics Forum | Tue Nov 02 03:24:33 EDT 2010 | Jacki
Yes, we use solder paste,solder bar and solder wire from different manufactureres for 1PCB assembly. And, what JAX said, we never mixed solder paste from different manufactures and used.
Electronics Forum | Mon Nov 01 13:43:18 EDT 2010 | jmatty35
I have a question regarding mixing different manufacturers solder pastes. We have a board being built by a CM that we are bringing in house and soldering a final cover onto the PCB. The contract manufacturer is using solder paste A. We want to use
