Electronics Forum | Fri Jan 30 06:20:43 EST 2009 | milas
Hi Does anyone have any thoughts on Lead Free solderjoints reliability in a high vacuum environment ?
Electronics Forum | Wed Jul 30 16:57:23 EDT 2008 | stevek
Folks, I'm looking for some specs for the maximum bend or strain that should be put on a PWB. Not looking at the solderjoints. I'm concerned with localized bending of the fab and what might be a reasonable limit for that bending. I've measured 105
Electronics Forum | Wed Jan 16 08:58:43 EST 2008 | Adam
Hi If I have an assembly where the solder joints are suffering from blowholes and Pinholes. Could these solderjoints be reworked/touched up to form a reliable/acceptable solderjoints ?
Electronics Forum | Thu Jun 25 16:07:44 EDT 1998 | G. Hamblett
Looking for articles/data comparing the quality/reliability of mass reflowed SMT solderjoints versus hand soldered SMT solderjoints.
Electronics Forum | Thu May 06 08:59:25 EDT 2004 | davef
Even with PbSn solderpaste the leadfree BGA's have a superior resistance to solder-joint fatigue failure when compared to conventional parts. [Solder Fatigue Reliability Issues in Lead Free BGA Packages, Pedro Chalco of IBM, Pan Pacific Microelectron
Electronics Forum | Tue Jul 22 20:14:34 EDT 2008 | stevek
It's been my experience that most flat pack land patterns have far too much exposed toe. It accomplishes nothing for the reliability of the solderjoint. And often the ends of the leads are sheared and not very solderable anyway. Anything more than
Electronics Forum | Thu Jun 25 18:28:23 EDT 1998 | Earl Moon
| Looking for articles/data comparing the quality/reliability of mass | reflowed SMT solderjoints versus hand soldered SMT solderjoints. As solder joint quality most often is subjective - that is visually compared with graphic examples, IPC is the B
Electronics Forum | Wed Sep 01 09:29:03 EDT 2004 | patrickbruneel
Hi Ken, It looks like you have some solid practical experience in the transition from leaded to lead-free soldering. I hope you don�t mind me asking a question. With conventional soldering we have a library of workmanship standards available (SMT,
1 |