Electronics Forum | Fri Aug 16 03:13:32 EDT 2013 | rollon65
Hi Marcelo. I have used 2 non EU model 4C machines since 2002 that do this almost every time from a cold switch on. My local Tyco tech guy said that they all do it. They are still going after 12 years. I have another EU machine that does the sam
Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance
When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Wed Dec 19 11:20:10 EST 2012 | aj
check for power going to the motor - trip switch at back of machine... Swap controller cards to see if the problem moves.
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Thu Jan 04 12:12:13 EST 2007 | russ
Well sure, the Chinese want to play mess up the world too!! This one has got to be power trip, and I would bet my bottom dollar that their RoHS only applies to import products. Russ
Electronics Forum | Wed Jan 30 09:32:56 EST 2008 | pms
Yea operator, what's with the disrespect from these little sweat-shop owners? There on some kind of wierd power trip. Like want-a-bees that never have been. The IDIOT-BOSS-OWNER here reminds me of satan. I would tell him to go to hell, but he's
Electronics Forum | Tue Aug 12 09:17:22 EDT 2008 | bobpan
We used a photo-optic sensor powered off the conveyor after the oven that is tied to a relay that trips when a board is seen at the sensor which causes a buzzer to go off. Very simple to make. Good luck.
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed