Electronics Forum | Sun Mar 22 14:51:35 EST 1998 | Martin Plourde
I'm looking for a Quadstar 100 with any top vision as well as a glue dispenser. Must have both features or I am not interested. I've located many Quadstars 100 with either features but my customer wants both absolutely Regards, Martin Plourde (514)
Electronics Forum | Tue Sep 30 09:21:08 EDT 2008 | eedlund
Anyone using a No-clean solder paste on a pcb with a 100 Mbps Ethernet chip? Will the residue cause any signal degradation? Any issues with a no-clean solder paste and 1000 Mbps Gigabit Ethernet? Device: National Semiconductor DP83848 10/100 Mb
Electronics Forum | Tue Sep 30 13:55:37 EDT 2008 | realchunks
How do you normally solder it?
Electronics Forum | Tue Sep 30 14:24:37 EDT 2008 | eedlund
A water soluble solder paste (AIM WS483), reflow and wash. We are considering using AIM NC254 No-clean solder paste to eliminate the wash step.
Electronics Forum | Tue Sep 30 18:06:43 EDT 2008 | realchunks
I would think if the product can take wash, it could take no-clean. Unless it has sensitive devices susceptible to leakage.
Electronics Forum | Wed Oct 01 07:51:13 EDT 2008 | mrmaint
We built tens of thousands of boards with transeivers on them with a no clean process.Never had any problems with the flux residue in relationship to board performance.
Electronics Forum | Tue Sep 30 20:55:14 EDT 2008 | davef
Residues from different no-clean fluxes produce different levels of variation in RF circuits. Some no-clean fluxes work fine. Following this, a no-clean flux can produce different levels of variation in RF circuits depending on the process setup.
Electronics Forum | Wed Aug 12 23:03:05 EDT 2009 | davef
Here's a boiler plate ITAR control plan http://www.cfisac.org/Resource/tcp.doc
Electronics Forum | Thu Feb 24 14:52:29 EST 2011 | davef
The above link appear to be broken. Try this: exporttexas.com/northtexas/doc/Sample%20TCP.doc
Electronics Forum | Tue Oct 18 10:36:46 EDT 2022 | winston_one
Dear proffessionals! Question is about this alloys - Sn99Cu07 and Sn100 (Sn100C,Sn100Ni+ etc.). Is it O'k to mix them? In my case to use Sn99Cu07 as addition to selective soldering machine bath with Sn100C? Main components are the same, but minor add