Electronics Forum | Mon Oct 15 10:51:49 EDT 2001 | davef
On over printing, the general issues are: * Paste deposits being so large that when reflowing, collapse onto many, rather than a single solder mass. * Paste expanding during heating and being close to other solder deposits and bridging [as you say].
Electronics Forum | Tue Apr 27 09:26:43 EDT 1999 | Chrys Shea
| | | Hey MoonMan, | | | | | | Did I catch in one of your fabulous threads that you're using Tetra stencils? I'm anxious to find out how you're liking them. | | | | | | We we're all set up to go to Tetras, then mgt decided to close down our factor
Electronics Forum | Tue Apr 27 05:26:14 EDT 1999 | Charles Stringer
| | Hey MoonMan, | | | | Did I catch in one of your fabulous threads that you're using Tetra stencils? I'm anxious to find out how you're liking them. | | | | We we're all set up to go to Tetras, then mgt decided to close down our factory - Dooop!
Electronics Forum | Fri Dec 17 13:23:15 EST 1999 | Chris
I have an underfill material which takes 6 hours to cure. It works great, better than any other underfill I have ever used. A vertical cure oven is too expensive. I am currently using batch style ovens and opening the oven door as additional produ
Electronics Forum | Fri Jul 23 13:49:29 EDT 1999 | Bob Neverosky
| | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performin
Electronics Forum | Fri Jul 23 23:47:03 EDT 1999 | Scott McKee
| | | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not perform
Electronics Forum | Wed Sep 18 12:35:56 EDT 2002 | stepheno
Fourth - > back to design of PCB. Are there solder dams of > mask between the pads? If yes, that helps. If > not, pay close attention to stencil aperture > width and be sure that the aperture deposits less > paste by 1-2 mils per pad, centered o
Electronics Forum | Wed Dec 17 17:40:58 EST 2003 | Barney
I am not sure where Dilbert is getting his information but the last I heard Contact was just about ready to close there doors. This information was from a customer doing bussiness with them
Electronics Forum | Fri Apr 30 10:42:40 EDT 2021 | oxygensmd
I have a customer who ask close to prototyping jobs with low volume and high-mix components. A regular job have around 5-30 pieces board but have high quantity and many type of components. All the time over 1000 pieces of parts on board from 250-350
| 1 |
