Electronics Forum | Sat Oct 25 19:02:45 EDT 2003 | Gabriele
Main difference is the reel holder position and for sure the clamping pin location. Tape feeding system is different. Any way they cannot be compatible among them. Q type feeders must be used for MV Q-Type placer and K-type feeders must be used for M
Electronics Forum | Wed May 10 01:00:09 EDT 2000 | gary
0.65mm pitch QFP. I believe that this is the borderline for Fine Pitch. Will I have a good paste release with Chem-etch matched with a rubber squeegee? I'm planning of a 15% reduction on the Width and no reduction on the length. Any feedback whether
Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit
I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot
Electronics Forum | Tue Nov 21 22:15:59 EST 2000 | Vince Whipple
Mohammed, The first suggested place to start with your question would probably be with your flux Mfr. Push them! The quantity of dross is effected by several factors: The higher your solder pot temp., the higher your dross level... but don't go too
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Mon Jun 12 10:46:37 EDT 2006 | mhanc
I am trying to help a customer with a problem. His Process Tech is out and the operator is trying to load a program via floppy. When trying to load on the Amistar 5630 the following errors occur: Data Type Error (level.4) we continue to load and
Electronics Forum | Mon Feb 05 21:56:31 EST 2007 | ViVian
what type of solder paste I should use if Rohs and non rohs component mount on same board
Electronics Forum | Tue Jan 08 16:43:04 EST 2019 | bane016
Try with "120F" type part number:48503503 or 1220 1240...reduce pick up speed...
Electronics Forum | Tue Jan 08 14:41:08 EST 2019 | jrogalski88
I am a fairly new technician with a rather large electronics assembly company. Its been an ongoing issue to pick and place small coils using our Universal SMT machines. Curious if any if the seasoned techs at smt.net have any recommendations as far a
Electronics Forum | Mon Mar 18 09:04:46 EDT 2024 | carl_p
Sounds like your talking very low volume & component counts really... I would look at Panasonic AM100 for example - low cost, high flexibility but you would need multiple so you could pair it with another... Ideally we would need to understand your
