Electronics Forum | Wed Jun 13 18:04:00 EDT 2001 | traviss
It is possible with a few universal profiles. I did this with 3 temperature ranges and 3 speeds for each, 9 profiles total. With this setup I could run any of about 150 boards most of them in the middle 3 profiles. My goal was to reduce change over i
Electronics Forum | Fri May 16 11:42:06 EDT 2003 | JB
We have used "feeder templates" in the past to keep components, that are shared by different products, on the same feeder slot number and it has worked well for us.We create a "master set up" say for product A that use 60 different components, the ne
Electronics Forum | Tue Jun 01 16:12:49 EDT 2004 | gregf912
The 10k rebuild does not need to be applied every 3-4 months as previosly stated. A cp machine that is running 100% of the time on a 24/7 basis will tack up 10k hours in 12.4 months. Now we all know that this is impossible due to parts shortages, pro
Electronics Forum | Thu Jun 21 22:04:18 EDT 2001 | davef
This is my attempt at beating the "Fuzzburg 7" translator used on the SMTnet Forum that mashes everything it sees. Below the next paragraph are three paragraphs,each with a common numering sequence, where each paragraph represents the columns of a t
| 1 |
