Electronics Forum | Thu Mar 30 12:48:54 EST 2006 | krc
Pardon my ignorance on this subject but I gotta ask... When the SMT guys load partial reels, I'm told that they have to waste a few components in the process. It seemed obvious to me that there should be a kind of tape that can be added to the end
Electronics Forum | Tue May 09 10:53:36 EDT 2006 | Tapesplice.com
Sierra Electronics can provide leader tape samples to any one that want to test. We can provide enough for testing at NO cost. We also have a Tape Splicer loan program that allows you to test ALL our Tape Splicing Products and lets you make the dec
Electronics Forum | Thu Mar 30 13:15:17 EST 2006 | gregp
Maybe the issue is how the feeders are being unloaded. The operators should leave enough covertape to reload the reel onto a feeder without component waste. If the issue is some parts are exposed in the feeder then you will most likely loose those p
Electronics Forum | Wed Apr 19 06:56:54 EDT 2006 | QTEK Manufacturing Ltd. www.qtek.com
QTEK Manufacturing Ltd. provide a solution to the above problem, QTEK Cover Tape Extender adds an extra 380mm to cover the tape of component reels. It saves components being wasted or discard when strating a new tape through a feeder, and enables the
Electronics Forum | Wed Sep 21 10:40:18 EDT 2005 | PWH
Splicing for us has been a rough go as we haven't really found a tool that works well/fast. We have a few different machines = different feeders. They all react different to a splicing "style". The best so far is a crimp tool that crimps a brass s
Electronics Forum | Wed Oct 10 20:35:17 EDT 2001 | djarvis
Stephen, I don't understand this at all mate. 1. If you don't place a QFP and get bridging across the bare pads, you were gonna get absolutely horrendous bridging if you did put one down. That points to poor printer set up or stencil design or both
Electronics Forum | Wed Oct 10 20:54:32 EDT 2001 | davef
We're with the Ozzy's earlier posting on this thread. We make similar products, like: * Phantom products that are mostly complete and then are configured to order by adding or subtracting a couple of parts and some jumpers. * Version products like y
Electronics Forum | Thu Jun 15 04:02:30 EDT 2006 | Rob
Hi Bert, It can be either - sometimes they put too much glue on the cover tape when it's sealed, and sometimes the feeder is not stong enough. We would get a lot of these on our fuji's after a shutdown, and they would diminish throughout the first
Electronics Forum | Sat Oct 27 14:57:00 EDT 2018 | jacobidiego
Hi Experts, I have noted a savings opportunity on our work-place as chipmounters discard carrier tapes which are easily separated in different waste-containers below the feeders. Normally the company pays a service to dispose that waste. Have anyon
Electronics Forum | Mon Apr 01 19:12:16 EST 2002 | Mike Konrad
�Cheap� is relevant. Is $ 3,500 for equipment cheap or expensive? If $ 3,500 is cheap, than we have a solution for you. If $ 3,500 is expensive, then purchase pre-saturated chemical wipes, latex gloves and a hazardous waste bin. As for �effective