Electronics Forum | Wed Jan 23 19:44:45 EST 2008 | hegemon
In addition to the pre-emptive steps mentioned above, in my experience there are certain BGA package designs that seem more prone to that corner bridging. I have seen some packages that will essentially "curl" down at one corner as the package begin
Electronics Forum | Thu Jan 17 11:49:54 EST 2008 | wayne123
HI, I have ran into this a time or two, and what I did before we got the BGA rework station was to run some flux under the component, and since the flux that was in the solder on the other solder joints has at least part of the way burned off in the
Electronics Forum | Wed Jul 01 18:49:27 EDT 2009 | stevenlimth
1smtdude, I interested in your explaination of re-work an underfill part. You mention the material can be heated to a plastic state to become vicious... do you know usually what range is the temperate? (guess it can depend on the type/manufacturer o
Electronics Forum | Tue Jul 14 18:42:41 EDT 2009 | anndi
1smtdude, I interested in your explaination of > re-work an underfill part. You mention the > material can be heated to a plastic state to > become vicious... do you know usually what range > is the temperate? (guess it can depend on the > type
Electronics Forum | Wed Dec 06 22:35:05 EST 2006 | davef
Questions are: * When you say, "corner of some board's BGA chips", is it on the top of the package or between the board and the bottom of the package? * If between the board and the bottom of the package, does it span the distance between the board a
Electronics Forum | Thu Sep 12 10:45:29 EDT 2002 | pbarton
We have used a laser cut stencil 0.15mm (0.006") thick with 0.3mm (0.012") square apertures radiused in the corners 0.06mm (0.0025") to aid paste release. This approach with the (type 3) paste we use has proven successful on thousands of devices plac
Electronics Forum | Wed Aug 27 00:20:38 EDT 2008 | rameshr
Dear davef, Will u pls advice what are all the possible defects caused while soldering ( assembling ) this type of boards.
Electronics Forum | Wed Jun 21 18:51:34 EDT 2000 | John
What is the most likely causes of shorts in the corners of BGA devices?. Is there a method of removing single shorts without removing the device?. John.
Electronics Forum | Fri Jun 23 10:01:35 EDT 2000 | Bob Willis
A couple of weeks back I produced a video clip for Metcal to show what happens when BGA pop or the edge of the base warps causing shorts to form. Its 2.3meg if there is enough interest in seeing this I will put it up some where for download. Bob Wil
Electronics Forum | Mon Dec 28 10:17:09 EST 1998 | Earl Moon
| Does anyone have any experience with vibration testing of BGA packages and assemblies? We are starting to design BGA's into some of our products and we have not found very much information on vibrational test results. Any information will be help
