Electronics Forum | Mon Apr 26 14:42:47 EDT 2004 | Kirk
so the first PCB if i want to aligned with stencil is manual the same for screen printer without vision and vision starts work for next boards? or i am wrong? but if i make mistake during aligment process for the first PCB i will repeat it for next P
Electronics Forum | Thu Apr 29 15:05:29 EDT 2004 | Kirk
we have sm-tech benchmark 90 and we think about Microflex with vision. how i teach the vision? I have two images. One is reference image and is it storage in system how can i create it (is it possible simply use paper as i said before then teach vis
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Fri Jun 09 07:56:25 EDT 2017 | prdmm1
our company has just purchased the MC110 High-Accuracy Manual Stencil Printer. the only thing I'm not sure about is how to use the PCB Edge Stopper. how is this used? the groove with the stoppers on it is too deep to hold a board because it would s
Electronics Forum | Wed Aug 07 14:51:31 EDT 2019 | alexeyzb
Hello! I used three SpeedPrint 210avi in our factory. They worked ok, but i had some problems: 1) Printer foil clamps. Steel thin blade which press PCB on table is connected to metal base by glue. As a result you need to change it every month, but af
Electronics Forum | Mon Jul 09 19:09:27 EDT 2012 | jorge_quijano
We used to have a manual printer machine, we could never align the stencil over the PCB well, now with the new stencil we have less defects but still appearing on the Top list. I tried to use more fids as you recommend and one issue I faced was that
Electronics Forum | Tue Aug 02 15:05:38 EDT 2011 | davef
A couple of points: * Just a nit, 'screens' fell in disuse 10-15 years ago. Old habits die slowly don't they? * Yes, DEK and MPM each hold about 50% of the solder paste printer market and about 4 or 5 others hold the rest. SOLDER PASTE PRINTER EQUI
Electronics Forum | Mon Jul 09 18:11:20 EDT 2012 | rsikora
Your selection of pads to use as Fids will be critical. In your pictures of the QFN component, the pcb pads are primarily non-solder mask defined, but on 3 sides of the QFN the corner pads become solder mask defined due to the copper ground flood.
Electronics Forum | Sun Dec 17 14:49:57 EST 2006 | kvanzill
Well, We have several lines some products run Kester 256 and others run the Timura. I have changed the product to print on another printer and it follows. We have several products that use the same paste and similiar board design that has a problem
Electronics Forum | Thu Jun 15 22:06:15 EDT 2000 | Dreamsniper
Hi Raeto, 1. You do not have reflow oven. This means that you are not running Surface Mount Technology in your shop floor...am I correct? Why do you plan to have SMD's under your PCB's ? Can't you replace them with their PTH counter part and have th
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
