Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Parts & Supplies | Pick and Place/Feeders
90990-08J024 YAMAHA Nozzle Screw 9498 396 01091 Valve KGS-M7176-00x 19 9498 396 01092 Cover KHG-M130A-00x 1 9498 396 01097 up/down cylinder KGS-M9904-01x 2 9498 396 01098 Valve assy KGS-M9917-A0x 1 9498 396 01249 Air cylinder assy KGR-M9612-00x
Influence of Nanoparticles, Low Melting Point (LMP) Fillers, and Conducting Polymers on Electrical, Mechanical, and Reliability Performance of Micro-Filled Conducting Adhesives for Z-Axis Interconnections. Influence of Nanoparticles, Low Melting