Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls
hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best
Electronics Forum | Thu Mar 02 05:07:51 EST 2006 | pavel
We have bought an old zevatech 730 in Bosch auction (hello MikeZIG). There seems to be something wrong with the X axis servo, the machine is vibrating when the head is moving fast (in fact the machine is dancing, in the race with washing machine it w
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Thu Feb 02 14:14:08 EST 2017 | siltron
Hi Muzzy, We are experiencing a similar issue with our Juki KE750, the machine did not perform zero rutine, some of the ALM4 led in the zeta ant theta drivers are turned on, and the SUB-CPU led "FAIL" is also on, did you mean that when your machine
Electronics Forum | Fri Mar 24 12:57:08 EST 2006 | wbartley
It sounds like a theta problem, you could have a bad theta motor or driver. Does this happen during warm up? And you can try and disable one head at a time and optimize your program after each head is disabled and then run your program. To see if you
Electronics Forum | Sat Sep 11 15:09:46 EDT 1999 | DGrenier
4 Mil Pcb's/yr) My choice was not to go to one vendor for a solution but, to pick (In my Opinion) the best equip to each of the jobs in a SMT line. Hence I have multi-vendor High Volume lines. Back to the ? Budget constraints and cost per placement
1 |