Electronics Forum | Thu Jan 14 06:03:51 EST 2021 | manaik
Hello, We have recently bought ZipaTec select 250, we are having problems with offsets. Somehow the offset of fluxer, wave and preheat dont match one another or the program we create. The previous owners are of no help. The main question i have
Electronics Forum | Wed Nov 02 11:14:45 EST 2005 | Doug
I am doing lead free testing on a Vitronics selective machine with a 4 mm nozzle. The finishes I am testing are ENIG, ImSn, and ImAg. The problem I am encountering is achieving good top side wetting. Has anyone had any luck with this type of an ap
Electronics Forum | Fri Apr 28 10:50:26 EDT 2017 | emeto
Hello experts, Here is my problem: I have a board that has smt parts on one side and TH parts on the other. We designed special pallet for wave, but the pallet itself is 15mm thick, so we are still seeing some defects. Have any of you tried to find
Electronics Forum | Thu Apr 21 10:25:44 EDT 2005 | Fred Saffer
A thorough analysis is in order because laser point-to-point soldering lacks the flexibility of the bottom sided miniwave systems. My experience showed that heating profiles could be grossly affected by color temperature and thermal mass. This can be
Electronics Forum | Thu Jan 03 11:25:07 EST 2013 | dontfeedphils
That's weird, I've never had any problems using the tool while the pot is up to temp. Over-tightened? They don't need to be tightened too much when putting them in.
Electronics Forum | Thu Jan 03 11:28:11 EST 2013 | beej
I have had a couple like this. It almost seems like they are not threaded correctly. I had to mangle the last one just to get it off.
Electronics Forum | Fri Jan 04 07:28:46 EST 2013 | beej
Thank you guys. I will check this stuff out. It quite possibly could be something we have done wrong. Thanks again for the feedback
Electronics Forum | Thu Jan 03 10:32:38 EST 2013 | beej
I was wondering if any of you fine folks had a trick to changing out nozzles for a Pillerhouse Jade Handex. The tool they gave us when we purchased the machine is inadequate at best. I have tried heating the nozzle up, to no avail. Just wondering if
Electronics Forum | Thu Jan 03 14:19:33 EST 2013 | uksolder
Beej, The tool supplied works well as long as the bath is up to temp and the nozzle tip was not cross threaded when fitted. Did you apply a small amount of the anti seize paste before the nozzle tip was fitted? I have seen dry tight threads if not ap
Electronics Forum | Fri Jan 04 14:31:35 EST 2013 | tombstonesmt
Thank you guys. I will check this stuff out. It > quite possibly could be something we have done > wrong. Thanks again for the feedback Add anti seize to the threads. We do this to all of our nozzles when we first "tin" them with Active8. We usua
.gif)
