Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Mon Dec 04 14:21:49 EST 2006 | jdengler
Todd, It's been a while since I have looked at this but I believe the IP-1 does not have a relay board for the feeders. +24 Vdc is wired to a pin on the connector and the I/O board (NO 3 I think) switches the ground. If you don't have +24 Vdc at 1
Electronics Forum | Thu Nov 11 18:36:29 EST 2004 | valuems
Hello We have been working on the MPM's for over 11 years now. And we have never had any trouble with that circuit, just goes to show you. If you have one of the old, old manuals you will find a lot of errors. They corrected them as they went. We
Electronics Forum | Tue May 11 10:57:35 EDT 2010 | ehess
Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I
Electronics Forum | Wed Mar 15 21:22:46 EST 2006 | bigdaddysoy9
The PILZ card, which is in the AC chassis, governs the safety circuit. Check for 24VAC going into the PILZ and 24VDC coming out.
Electronics Forum | Tue Dec 05 14:23:55 EST 2006 | Todd
I'm not finding 24Vdc at any feeder location?! I checked all pins with the coresponding feeder activated through the I/O and a key in the emergency disconnect. Am I not using the correct procedure to check for my 24V?
Electronics Forum | Tue May 25 03:41:50 EDT 2021 | ppcbs
Looking for a Pittman Motor for an SRT Summit 1100. It runs the pick up tube up and down. Gear ratio is 11.5:1 Around 24 vdc.
Electronics Forum | Fri Mar 23 02:22:13 EDT 2007 | bvdb
Latest information: The IP-1 packed up completely this week showing an assortment of weird error messages. The CPU was still running but the +24VDC power supply LED was off and nothing would work (emergency stop mode always enabled). Pulling the +
Electronics Forum | Wed Oct 20 01:43:34 EDT 1999 | Jorge L. Torres
We have a Yamazen PK-32E Magazine board Loader. It appears that at one time or another was connected with a Sanyo Pick & Place machine, which is a 24VDC system for SMEMA. I want to connect it to the DEK265 printer, which currently has an inspection s
Electronics Forum | Fri Aug 18 09:29:20 EDT 2006 | chrisgriffin
I would measure the voltage on the yellow wire going to the air pressure sensor. Are you getting 24VDC? If so, maybe replace the input DC module on IO card #2. I think it is IDC module 8 on that board. Try not to have too many violent thoughts.
