Career Center | , New Hampshire USA | Engineering,Management,Production,Quality Control
Searching for a Sr. Director or Vice President of Quality to take on all quality and manufacturing issues in this rapidly growing electronics manufacturer with a new focus on the Optics manufacturing sector. You'll report directly to the President i
Career Center | , New Hampshire USA | Engineering,Management,Quality Control
Stable, award winning Electronic Manufacturer, which provides services to the telecommunications, optics, pc, and medical device industries, is urgently searching for a VP of Quality for their New England facility and will have multi-site responsibil
UL544/2601/1950, CSA/IEC/EN 60601.1/60950, EN 61000-3-2/3, CE marked, Medically Approved Power Supplies for Patient Contact applications. Resonant Power provides 40 Watt to 500 Watt open frame AC-DC converters certified to meet the European Medical D
Career Center | Eden Prairie, Minnesota USA | Production
Solderer ALL SHIFTS Logic PD collaborates with clients to help them launch products that accelerate growth and capture value in the Internet of Things (IoT). Logic PD helps at any stage in the product lifecycle by being the complete product innovat
Electronics Forum | Thu May 19 07:06:59 EDT 2005 | py
have you some GND layer inside the pcb ? see IPC 610 A
Electronics Forum | Fri Dec 09 13:32:14 EST 2005 | jbrower
Hi Ajay, Does your company currently use any quality standards or is it made up as one goes by the QA department? You might find that using IPC 610A Acceptability of Electronic Assemblies very usefull. This manual is our base line for acceptable or
Electronics Forum | Thu Apr 05 09:18:14 EDT 2007 | pjc
Please note that pin holes and blow holes are not always defects. The latest IPC 610A Rev D workmanship standard has them as process indicators- depending on Class. I don't have the document handly while writing this. It would be good to look that up
Electronics Forum | Mon Jul 29 08:34:40 EDT 2013 | gallionc
I don't see an issue. As was mentioned before, it is what the customer wants. You could approach this from one of two ways. You could simply install the parts, clinch the leads on the opposite side for added mechanical strength and solder the parts
Electronics Forum | Wed Feb 28 00:01:47 EST 2007 | Muhammad Haris
Hi, The distance between the two terminations/endings/pads of 0603 (0201)is 0.15mm i.e. lesser than than the distance between the 0603 and through hole i.e. 0.5mm My ques is that, then why its termination doesnot short as it has a minimum distance.A
Career Center | north augusta, South Carolina USA | Production,Quality Control
Detail oriented!
.gif)
