Electronics Forum | Wed Jun 20 12:16:59 EDT 2012 | allgood
Hi John Yes I am still having the same problems years later! It keeps Fred in work supplying me with replacement tips too! Mydata came up with a supposed fix to alter a parameter called prepick which puts a pause in I think allowing the head to st
Electronics Forum | Mon Jul 09 18:11:20 EDT 2012 | rsikora
Your selection of pads to use as Fids will be critical. In your pictures of the QFN component, the pcb pads are primarily non-solder mask defined, but on 3 sides of the QFN the corner pads become solder mask defined due to the copper ground flood.
Electronics Forum | Sat Jun 01 11:15:34 EDT 2013 | aemery
Delete the program and start over. I can't get a clear understanding the way you described the error, but it does sound like you have some kind of detent issue or a board stop programming issue. Depending on the configuration of your machine and th
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
Electronics Forum | Mon Jul 14 12:11:17 EDT 2014 | rgduval
We used to use the Tapesplicer tool available from http://www.tapesplice.com (Sierra Electronics), in a high mix, low volume environment with MyData's (older feeders). Short review: It worked. Longer review: First, technique is everything. Splicin
Electronics Forum | Tue Apr 03 01:39:43 EDT 2018 | sophyluo1985
Dear Sir, Regarding the problem of the SM feeder doesn't power up, the following test steps are sorted out. Once it is not clear or you can't solve the problems you have, please contact with me if you want. My whatsApp is: +86-13823675048, skype is
Electronics Forum | Fri Apr 05 07:17:40 EDT 2019 | jchris
We evaluated the Metcal CV-5210 and found that while it is a solid iron, the "Connection Validation" features were so quirky that our operators had to completely turn off the CV features. When Connection Validation was enabled, we had a massive amoun
Electronics Forum | Thu Apr 09 20:18:31 EDT 2020 | jlawson
Can not speak for CircuitCam is made by Aegis Software I veliveve sound like need to get understanding of how tool is supposed to work to extract-create centroid positions. Using Gerber Only is a pattern match and cacluate logic process - ie make pac
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Tue Sep 07 14:24:20 EDT 1999 | johng
| | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji d
