Electronics Forum | Mon Apr 25 17:46:04 EDT 2011 | ldavis
I think Patrick is on the right track. Try running the fixture 180deg out from typical, if possible, and see if the problem goes away or moves to another fuse clip. I've also noticed some wave fixtures can create air pockets that won't allow proper
Electronics Forum | Wed Jun 01 01:08:43 EDT 2011 | boardhouse
Hi Aj, for the most part we have gotten away from calling out specific material and instead calling out IPC4101 back slashes to needed requirements. But if you are just looking for what most domestic shops have switch to you would be looking at 370
Electronics Forum | Wed Nov 23 16:53:09 EST 2011 | davef
There's a lot of excellent dispenser suppliers out there that will willingly claw their competitors' eyes out to get your business. Note: Camalot Essemtec Asymtek (Nordson) Precision Valve Creative Automation GPD IJ Fisnar Janome Fuji NE3000S fuji
Electronics Forum | Fri Mar 09 05:06:09 EST 2012 | grahamcooper22
Is your solder paste deposit drying out? Or if the paste deposit is small or there is insufficient paste then the tack between the device and paste will be poor so it can easily come out of the paste during its placement or placement of other parts.
Electronics Forum | Fri Mar 15 12:48:01 EDT 2013 | anvil1021
Hello All.....wondering if anyone out there has needed to isolate a QFN ground pad from the device and how you may have gone about it. We are thinking about using a micro drill to remove the pad, but if anyone out there has a better idea I would be v
Electronics Forum | Mon Apr 01 14:26:43 EDT 2013 | babe7362000
Sounds like you need to be at a different level of operator. They may have had operators locked out. You will need to know the password or if you know dos well, you can find it out there. You can also call PPM for assistance. Just search PPM and yo
Electronics Forum | Thu Jul 25 16:13:46 EDT 2013 | markhoch
We occasionally have the same issue with ours, but it is caused when the sensor, (that is supposed to detect when the magazine has emptied), has been knocked out of alignment. If you a transmitter/sensor set mounted at the exit end, make sure that i
Electronics Forum | Tue Jul 01 20:39:45 EDT 2014 | chantel
Thanks so much. That was definitely the issue and I was dealing with an issue of the tip not picking up some of the parts. Then, today found out a piece of dust ball was in the vacuum and was able to blow it out, by means of deduction from the sensor
Electronics Forum | Mon Sep 15 10:22:45 EDT 2014 | island2013
Sounds like all the usual suspects have been replaced. How about some completely random thoughts. For this specific product, you mention it runs a few boards then fails out. Does it fail out on one specific fiducial on this product every time or i
Electronics Forum | Sun Nov 09 15:03:20 EST 2014 | warwolf
Google doesn't return anything with this one. Your best bet would be to take them out and look for obvious damage, check that the relays are working/fuses are okay and what not. If its anything like the PLC that has died then you'll be out of luck.