Electronics Forum | Fri Nov 13 07:03:44 EST 2009 | davef
Loco [snip] "The print mode is another consideration. Printers are designed with a squeegee bar and a flood bar. In flood mode the flood bar spreads the paste, and in print mode the squeegee applies pressure, such that the actual printing takes plac
Electronics Forum | Fri Nov 20 08:51:34 EST 2009 | Sean
Hello, This is interesting topic that I would like to share and discuss with you.. I came across few projects from various SMT factories where its product(Computer) reach field, experience No Post/boot defect. This problem become very obvious when
Electronics Forum | Sat Feb 27 00:59:43 EST 2010 | jmelson
Hi, I have a CSM84, PA1306/20. When I got it, a lot of the offsets had been zeroed out. I figured out a procedure to calibrate the back feeder rail, but haven't come up with a scheme to calibrate the mechanical alignment unit. I have it close, but
Electronics Forum | Thu Feb 18 18:25:33 EST 2010 | tony_d
Hello Bryan, My recommendation is MIRTEC by far. We checked out several machines and narrowed the selection down to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. We found that the MIRTE
Electronics Forum | Wed Nov 03 14:08:55 EDT 2010 | clampron
Good Afternoon, I would throw my vote in to Mirtec as well. I also had an opportunity quite a few years ago to compare three systems side by side. At the end of the evaluation, the Mirtec stood out over the rest. Over the past several years, I was in
Electronics Forum | Thu Jan 13 10:40:38 EST 2011 | tony_d
Good Day Michelle, If you are looking for a solid AOI system that is simple to program and extremely accurate my recommendation is MIRTEC by far. We checked out several machines and narrowed the selection down to two, YESTech and MIRTEC. We had an
Electronics Forum | Thu Jan 13 20:20:45 EST 2011 | hegemon
Not sure this would be of some help, but in the past I worked in the OEM industry in a fully No Clean process using A*M NC Solder. If customer expectations cannot be tempered, you're stuck cleaning the No Clean. To remove the NC residue, (which we
Electronics Forum | Wed Jun 22 22:48:46 EDT 2011 | tony_d
Hello NHTech, When it came time to invest in AOI, my team and I checked out several machines. We run a wide variety of products and our changeover is high, on the order of five to ten jobs per day. MVP is one of the machines that we looked at, how
Electronics Forum | Fri May 11 11:15:03 EDT 2012 | shawnvike
Good question and always fun to wade through all the issues. We currently run an Essemtec FLX2010 and a Manncorp CR-6000 oven. Our printer is an Essemtec SP002 (I think) guided manual. We have been running the Essemtec equipment for ~6 years and ha
Electronics Forum | Fri Jun 01 10:52:37 EDT 2012 | blnorman
Neither the Omega meter nor the IC are officially "destructive" tests, but everywhere I worked we treated them that way. The boards were scrapped after the test. The Omega meter can be tested at elevated temps, but the IC sample is extracted at ele