Electronics Forum | Thu Sep 16 21:11:10 EDT 2004 | davef
Left to its own devices the plastic used to seal your parts will take-on moisture in the air. When you heat there parts the water in the part expands and can damage the part, if not properly demoisturized. The instustry standards for controlling su
Electronics Forum | Wed May 04 04:31:44 EDT 2005 | siverts
What is the MS-level and floor life of the critical components (should be written on the MSD-bag)? What is Your climate condition in the production area (%RH, temp.)? Are you doing this inspection on every board or is it enough to do it on the first
Electronics Forum | Mon May 16 15:29:53 EDT 2005 | jdumont
We have the exact same issue with out 456 ball Xilinx parts. The corner balls either do not touch or are so stretched out that they are intermittant. I believe this to be a moisture ingress problem. Ive been setting up our little batch oven this afte
Electronics Forum | Wed Feb 15 09:00:46 EST 2006 | GS
if you look at the J-STD-033B, you will see that such a large PQFP could stay even longer the 24h at 125�C even if internally is already totally dry. It could be, the balls can get oxided and also IMC (Inter metallic compounds) could grow avery littl
Electronics Forum | Wed Nov 29 01:46:10 EST 2006 | hanocete
Hi! to all, Here in our company, we sometimes received BGAs and ICs that were packed poorly(not sealed), and no MSL level written to it from our suppliers, now we subject the material for baking before using it. We use J-STD-033B table 4-1 as our cr
Electronics Forum | Mon Mar 05 11:51:21 EST 2007 | muse95
Join the "big issue" club. We were just reading the "fine print" (no, it wasn't fine print...) in J-STD-033, and noticed that we overlooked the requirement that when baking at 40C (or any temp below 100C) the humidity in the oven must be controlled
Electronics Forum | Thu Apr 12 13:04:47 EDT 2007 | slthomas
Handling requirements of all classifications of moisture sensitive devices is found in J-STD-033. It really isn't an issue for most parts unless they're going to reach reflow temperature again, which is unlikely unless you're removing a nearby compo
Electronics Forum | Tue Jun 09 18:44:20 EDT 2009 | dyoungquist
We are using a water soluble flux which requires the assemblies to be cleaned in an ultra sonic cleaner after assembly. Is there a standard that specifies how long the assemblies need to be baked/dried after being submersed in a water solution for a
Electronics Forum | Fri Sep 04 02:27:48 EDT 2009 | hurr
Hallo all, when I remove one from us malfunction BGAs from PCB I saw under X-ray inspection inner hairline crack.(see fig.1.) BGA was dried according to J-STD 033 and reflowed in lead process. When I look at new (baked BGA) under X-Ray inspection I
Electronics Forum | Wed Mar 24 16:54:38 EDT 2010 | stepheniii
J-STD-033B.1 Says "For cavity packages in which water may be entrpped, water clean processes after first reflow can be an additional source of moisture. This may present an additional risk, which should be evaluated." And it talks about derating if
