Electronics Forum | Mon Aug 13 08:00:46 EDT 2007 | davef
Are the components that fall from the board solderable? Is the board solderable? Where is the solder for the components that fall from the board [eg, on the pads, on the component]?
Electronics Forum | Thu Jun 22 12:25:07 EDT 2000 | Boca
Jason, What Chrys said! Don't try to run the bottom cooler, tried it in the mid 80's, don't work and don't want it to work. If one side of a fab is maintained cooler than liquidus and the other side into reflow it would have an easy 40C temp diffe
Electronics Forum | Tue May 14 21:07:03 EDT 2002 | ianchan
Hi mates, Yes, the lighter mass is a valid reasoning. in addition to the "lighter (mass) than thou" point of view, 1) the first reason for mounting active Parts (eg. IC, QFP, LGA...) is to minimize the temperature exposure of the Parts to a single
Electronics Forum | Mon Jul 10 11:38:15 EDT 2006 | Rob
Hi Dougs, I think I'm going to have to admit to some insider knowledge here. It kind of gave it away when you mentioned there were only catalogue pages instead of specs. http://www.anglia.com/product_search/part_tracker/index.asp I think you may
Electronics Forum | Wed Jun 15 08:45:25 EDT 2011 | edmaya33
check your reflow chain. it maybe vibrating causing DPAK to fall at second reflow.
Electronics Forum | Fri Aug 10 14:43:27 EDT 2007 | judym
When running some double sided reflow boards through the Heller oven, some of the caps/ res's are falling off the bottom side of the board. I understand if the parts are too heavy they wont stay in the molten solder, but these particular parts are no
Electronics Forum | Wed Nov 21 08:45:33 EST 2007 | davef
Rob: You say, "We usually determine our run process based on the heaviest components, and propensity for falling off during the second reflow process. If there's only the one BGA on that side of the board, we'd tend to run that side first." We agree
Electronics Forum | Fri May 21 15:40:58 EDT 1999 | JohnW
| | | hello...can somebody help me regarding the POPCORN at Reflow. What is this POPCORN at reflow, what it looks like, its cause and corrective action if there is... | | | | | | your help is greatly appreciated...thanks | | | | | | omat marasigan
Electronics Forum | Tue May 07 22:25:15 EDT 2002 | L_ch
Hello, As you know for the double side assembly PCBs, we normally first place the bottom side, then place top side after reflow soldering of bottom side. are there any other considerations for the sequence of reflow soldering ( bottoms side first, to
Electronics Forum | Tue Nov 20 09:50:07 EST 2007 | rgduval
Only on the bottom side? Run that side first . We usually determine our run process based on the heaviest components, and propensity for falling off during the second reflow process. If there's only the one BGA on that side of the board, we'd tend
