Electronics Forum | Mon Nov 20 04:04:42 EST 2000 | Gyver
Sirs, Please do me a favor to answer the following questions, thanks a million! 1. Will the baking of BGA or PCB cause more oxidation before the SMT process? 2. What is the acceptable Life Time of solderability at customer site? The time that the sol
Electronics Forum | Thu Jul 11 20:36:43 EDT 2002 | cyber_wolf
It will place BGA's, but you will be centering by using the part outline. The IP2 cannot be adapted to do individual ball inspection.(You may already know this) As far as getting the part to stay on the part shuttle, I am sure that there is somethin
Electronics Forum | Fri Jul 12 12:04:51 EDT 2002 | jax
The Lizard Tongue is just a thin metal strip that, when actuated, slides over the BGA component and holds it down during transport. If you contact FUJI, they should be able to give you a part number, and install instructions..... maybe even the real
Electronics Forum | Mon Apr 02 01:24:52 EDT 2007 | Haris
Dear all, I want to know the difference between the CSP and the BGA (I think there is only in the mesh pin difference). Secondly, if their solder balls have same dia, LxBxH are also same with the the manufacturing of the pin coating chemical elemen
Electronics Forum | Thu Jan 15 12:55:03 EST 2004 | James
Polarity in tape and reel is usually always on the bottom left side. And that is correct for the trays, they have a corner taken out where the polarity goes. Hope that helps........
Electronics Forum | Fri Jun 19 13:40:25 EDT 1998 | Terry Burnette
| Has anyone had experience with placing BGA on gold plated boards. I thought I read a while ago there was a problem with embrittlment causing cracked joints. If anyone has experience with this your feedback would be great. | Mike There has been a
Electronics Forum | Thu Apr 05 08:44:45 EDT 2007 | ck_the_flip
"Guest" is right, actually. CSP's are essentially BGA's, but typically the pitch and ball diameters are much smaller and in some cases, the pads of the CSP's can not be screen printed. If that's the case, you'd have to have flux-dip capabilities on
Electronics Forum | Fri Jun 19 14:25:24 EDT 1998 | Earl Moon
| | Has anyone had experience with placing BGA on gold plated boards. I thought I read a while ago there was a problem with embrittlment causing cracked joints. If anyone has experience with this your feedback would be great. | | Mike | There has b
Electronics Forum | Thu Sep 07 15:24:29 EDT 2000 | Murad Kurwa
Steven, Try http://www.document-center.com/home. You will find various standards for BGAs freely-available but not for free. BTW, I have never seen a BGA underfilled. Only FC and CSPs. The standards available will explain when to.....High CTE delta
Electronics Forum | Wed Apr 28 14:41:45 EDT 1999 | Bob Willis
| | What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? | | | | Thanks, | | | | Frank | | | Frank, | Refer to the device manufacturers. they are going t
