Electronics Forum | Tue Sep 24 23:03:14 EDT 2002 | redmary
we used the ball bonding, just normal chip on board. as I know the the electroless Ni/immersion Au, the gold thickness is about 0.13um at most, what about chemical plating or electrolytic plating? any experience on it, thanks
Electronics Forum | Tue Oct 07 02:18:13 EDT 2003 | iman
Hi Experts, Pls help advise what is the expected range of PCB gold thickness over Ni (for ENIG/Electrolytic fabrication processes)? any referrence standards set by the IPC?
Electronics Forum | Fri Mar 05 00:53:09 EST 2004 | alwil
I have an Electrolytic capacitor which is 17mm in diameter and is 16.7mm in height. It is presented in a reel,44mm x 24mm. I want to know if there is a suitable feeder available to place this part onto a Fuji IP3. Thanks, Alan.
Electronics Forum | Mon Aug 16 18:09:33 EDT 2004 | Kris
ok I agree there has been a confusion with terminology When you say electrolytic soft gold with a minimum thickness of 5-8 of Au, is there a standard that you spec this from ?
Electronics Forum | Wed Jul 27 06:07:35 EDT 2005 | Rob
Ah, so that's where the knowledgeable authoritarian style comes from. It all fall's into place! Rob. ;-) (Former exploder of electrolytics, and gas tap flame thrower pioneer)
Electronics Forum | Thu Aug 11 16:38:36 EDT 2005 | russ
Don't have a picture but a ribbon lead is jaust a flat lead with no standoff capability. look at a SMT electrolytic cap for this lead type.
Electronics Forum | Mon Oct 31 13:37:51 EST 2005 | slthomas
I would second the hot melt glue method. You do have to teach the importance of "more is not always better" and there will be learning curve, but it's a lot better at securing big clunky electrolytics than RTV. It's also a lot cheaper than chipbonder
Electronics Forum | Mon Mar 27 11:24:59 EST 2006 | mac
Had similar issue with Omniflow. Was actually jostling tall electrolytic caps off of pads. Found that idler sprockets/pulleys needed lubed.
Electronics Forum | Tue Nov 14 01:28:10 EST 2006 | CHITRA
When we reflow solder SMT PCB with SMT Electrolytic capacitor- 5MM sized ,the capacitor gets burst and all other adjacent and surrounding components also get disturbed. What could be reason for this. What should be done to avoid this problem.
Electronics Forum | Mon Feb 05 16:33:40 EST 2007 | slthomas
Not sure what you mean by thicker embossed tape. I've only seen one thickness as far as the tape, but I have seen electrolytic caps on tape that were too tall for the feeders.