Electronics Forum | Sat Jan 24 15:52:53 EST 1998 | Bill McKnight
| Has anyone experianced Core Dump errors with their MYDATA TP9? | My machine (2/96) has 26 million placements and my operators | have recorded 253 core dumps in 1996, 238 in 1997, and 18 in | January of 1998. We run one job on the machine, period.
Electronics Forum | Thu Jul 20 11:18:43 EDT 2006 | ev
Paul, the error says "MOT1-38-247 MSETDYNX: Xwagon fan not working." I have checked...the X motor fan and it is working...the fan behind the PAIB board is also working...I checked this because there is a connector marked X wagon fan on the PAIB boa
Electronics Forum | Thu Jul 15 11:28:24 EDT 1999 | Russ Supersano
I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed and I had to reload the software. I re-insatalled Venix then the CP4 driver then TPsys and Ser
Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Mon Oct 22 16:33:14 EDT 2018 | tey422
To narrow down the cause. Have you test it on all your tools? If only particular tool(s) having issue, then it might be tool that's having the problem.
Electronics Forum | Tue Oct 23 00:52:16 EDT 2018 | filipblad
Yes, for all tools... The tool head stops just above the tool
Electronics Forum | Wed Oct 24 00:36:59 EDT 2018 | filipblad
I've checked the locks in the service program and the solenoids move when told to.. also I can see them opening when going to pick up a tool..
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
.gif)
