Electronics Forum | Wed Oct 14 19:32:14 EDT 1998 | John Godfrey
I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info about the machines which give you the best bang for floor space. I need a 2 machine system for placing 0402 to fine pitch, B
Electronics Forum | Tue Mar 13 12:03:29 EST 2001 | LSMITH
Get another machine poopdick
Electronics Forum | Mon Mar 24 22:46:53 EDT 2008 | crashoveride
Don't try the mecha check yet unless you know how. have you checked the coupling shaft of Y-axis? If it's ok, take a look at the ball screw if it looks like being scratched or something unusual. Also, observe the movement of the machine if you hear a
Electronics Forum | Fri May 23 12:18:59 EDT 2003 | vortex
First off is your CP4 0402 ready? Before we could begin placing 0402's we had to have a vision upgrade. Once you have that or are sure your machine can handle 0402 then you will have to get 8x2 feeders. There may be a way to rig an 8x4 feeder but i'm
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Fri Sep 09 08:37:38 EDT 2016 | williamaxler
Amistar Dataplace is an inline label printing and placing machine. I have used one in the past will good results. http://www.amistarautomation.com/data_place.htm
Electronics Forum | Thu Dec 21 16:56:03 EST 2000 | lucky
I do not think so. The 54 mm has a large field of view, so when it looks at small parts the image is blurry. What you want to try is using the other camera (camera 2) it has a 38mm field of view. Camera 2 is considered a narrow field of view, the cam
Electronics Forum | Tue Mar 13 12:15:14 EST 2001 | onset
We have a 4C and it places 0402 components without any problems. The tricky part is getting the machine to pick them up out of the feeder it takes patience but you will get it. jake p.s. you
Electronics Forum | Thu Nov 17 17:44:19 EST 2011 | bobpan
Tim, 1. You dont need the vacuum verify if the quadalign is working properly. If you have the part quad-aligned and dont have alignment type at 0 it will never 'not' place a part. More or less...the vac verify was needed for the chucking machine (3c)
Electronics Forum | Wed Mar 19 15:59:40 EDT 2008 | rmitchell
Hi, I am having some problems with my CP6 placement changing in the Y axis. I had to move all parts by +.12mm this morning. Then after 20 boards the placement shifted too high by about .12 mm The IP stayed the same with the same pcb's and fid coo
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774