Electronics Forum | Wed Dec 04 09:24:52 EST 2002 | jseagle
I have found that preheating the solder pallets prior to use helps cut down on the solder balling. Also, we do not cool the pallets between passes and we use a spray fluxer because a hot pallet will knock down the head on a foam fluxer. We use WS f
Electronics Forum | Wed Oct 25 11:33:44 EDT 2006 | bill
I have inherited a SonoFlux 9500 spray fluxer. It appears to have never been used and was build in 1999. It is missing the nozzle and a couple of other parts. Would it be worth it to get this thing up and running to replace a foam fluxer? Does an
Electronics Forum | Fri Jun 22 11:09:01 EDT 2007 | realchunks
Sup G! Normally when spray fluxers get neglected, the spray pattern is the first thing affected. To actually 'see' this, we cut out a piece of cardboard the same size and length of the board. Run it over the fluxer and then turn itover and look at
Electronics Forum | Tue Feb 27 18:13:03 EST 2001 | davef
First used a Binks for painting a '57 Chebby that Wesley B and I were rebuilding. We still use them for spraying conformal coatings. If Chrys was here, she�d freak. Look at: http://www.smtnet.com/library/index.cfm?fuseaction=view_article&article_i
Electronics Forum | Fri May 14 17:19:34 EDT 1999 | Herb Pabes
Hi Chrys! I've also heard stories of the water-based material "attacking" the inner workings of their spray nozzles - probably due to the water hanging around parts and corroding them. Did you have any such problems with the USI ultrasonic sprayer?
Electronics Forum | Mon Feb 28 16:04:30 EST 2005 | Alex
I use to have that kind of problems with other type of machines and here are the causes: 1- Spray fluxer head partially obstructed (check flow rate) 2- Defective pre-heater probe (manually check temps) 3- PROFILE (last preheat to 280) 4- we sometimes
Electronics Forum | Tue Aug 24 22:32:18 EDT 2004 | pdeuel
We have a Soltec Deltawave with single nozzle spray fluxer, chipwave, and waveform. It preforms well. I am not fimilar with Electrovert models so I can only give you some of the pitch I got when I went back East for training. Features I like about th
Electronics Forum | Mon Oct 16 16:01:42 EDT 2006 | timnop
I have a wave machine (offshore made) with internal spray fluxer configured with a conventional spray gun set up. In order to spray fluid (in this case, flux) I must set the air pressure at 0.3 mPA (43 PSI). At that pressure, my flux sprayer creates
Electronics Forum | Wed Sep 20 10:36:27 EDT 2006 | proy
I am considering moving my spray fluxer into a completely separate operation. Has anybody any comments of sraying VOC free flux on boards, then putting them in a drier/holding rack for possibly say overnight, then running them through wave solder?
Electronics Forum | Tue Dec 21 13:27:47 EST 1999 | Vince Whipple
Charlie: As far as setting up a spray fluxer.. Are you spraying no-clean, voc free, water soluble? What you would want to do is to run a blank pcb through the fluxer and pop it out before the preheaters. Visually inspect for variations in uniformit
