Electronics Forum | Fri Mar 20 01:09:26 EDT 2009 | padawanlinuxero
Have the same problem but I do it manually in MYDATA when I check the feeder�s position I can change the orientation there.
Electronics Forum | Mon Apr 13 12:32:55 EDT 2009 | ericthered
That would be great Armando, thanks. Also, what changes might I make with metal clad light boards (LED). heat transference is tricky with these and the solder is not wetting well.
Electronics Forum | Thu Apr 09 21:21:11 EDT 2009 | qualityguy
Hello, another SME is saying the solder resist cure level is suspect. I have had a industry SME make reference to this too. Adjusting the cure of the resist changes the surface energy
Electronics Forum | Tue Apr 14 08:13:08 EDT 2009 | kpm135
If you plan on loading offline to get the most out of your machine time every day then they are a must. If you don't care about that and how long your change overs keep the machine down then I guess they don't matter.
Electronics Forum | Fri Apr 17 10:21:20 EDT 2009 | padawanlinuxero
have you try to change the stencil apertures to another figure like the one that look like a baseball home? I was having that problem and some solder beads and with that I was able to decrease the tombstones
Electronics Forum | Wed Apr 29 08:55:49 EDT 2009 | nibirta
was the first thing we did. No improvements. In the meanwhile we have change the lot of the components. and it seems that there is humidity absorbed by the components. we are cooking now the lot and waiting for improvemnets. thk u for the support
Electronics Forum | Fri May 22 09:51:57 EDT 2009 | dwl
They're at it again: http://www.nema.org/gov/env_conscious_design/index.cfm Our benevolent government wants to change my processes, and incur massive additional production costs to fight a problem that does not exist...
Electronics Forum | Tue Jun 23 06:01:24 EDT 2009 | brucow
Hi All, The x-axis ballscrew on the x-y table of our Fuji CP642 is getting very noisy. Could someone in the know please run me through the procedure for changing the ballscrew and will any calibration be required after fitting? Any help much apprec
Electronics Forum | Sun Jul 12 21:15:31 EDT 2009 | padawanlinuxero
a more general solution is have you done some cleanning in the vaccumm for the nozzles? change the filters or filter?
Electronics Forum | Mon Jul 27 20:35:13 EDT 2009 | michaellaw
This is the common problem for RH6 m/c.You need to check of the following: 1)Make sure the spiral corl is secure properly especially near to detection amplifier box 2)you may try to fine tuning the sensibility VR on the detection card. 3)change the t
