Electronics Forum | Mon Apr 14 13:24:46 EDT 2008 | ethancw1sel
Anyone have good luck rounding up part numbers for Assembleon part numbers for their feeders? It's rough trying to get them through the company it's self, and the manual's are not that helpfull.
Electronics Forum | Wed Apr 16 09:30:09 EDT 2008 | swag
IPC-7530 might help some but will cost you a little. We have an older OmniFlo that has a pretty good section on all that in the manual if you happen to have one of those.
Electronics Forum | Wed Apr 30 12:25:09 EDT 2008 | realchunks
Paraffin wax. Before you laugh, check it out. http://en.wikipedia.org/wiki/Paraffin_wax#Wax Only draw back is you have to melt it, but works well on electronics.
Electronics Forum | Wed Apr 30 15:00:51 EDT 2008 | mikesewell
I believe Humiseal (and others) makes some water based coatings...www.humiseal.com Dymax has a no VOC UV cure if you have an adequate UV source.
Electronics Forum | Fri May 02 18:44:16 EDT 2008 | jlawson
Humiseal has no-VOC coatings Acrylic and Urethane on offer, they too have non-VOC silicones and new UV curable also...!!!
Electronics Forum | Thu May 08 11:33:23 EDT 2008 | rkeck
I am looking for information mainly for installation instructions for the Infra Flow 5 oven. Anyone that has experience with this oven as far as exhaust requirements or has a manual they could access, please contact me.
Electronics Forum | Thu May 15 15:12:03 EDT 2008 | mgrimes
I have a copy of this manual I could send to you. You can email me at matt@easiky.com.
Electronics Forum | Fri Jun 06 14:08:37 EDT 2008 | rodrigo
Hi Muarty, I thought you could see my email but I guess not. This is where you can send the files: dsp1024 at yahoo dot com. Thanks
Electronics Forum | Tue Jun 03 20:09:31 EDT 2008 | fastek
Look in your manual. There are also calibration stencils and boards necessary to calibrate DEK printers. Do you have them? If not I might have a set I would sell.
Electronics Forum | Fri Jun 27 18:04:37 EDT 2008 | jmelson
Yup on the confusing thing. My manual assembly guy made the same mistake and we burned up a little batch of their parts back around 2001 or so. Jon