Electronics Forum | Tue Mar 16 15:59:40 EST 1999 | GSM GURU!
| I am in need of feeder that that will feed a 76mm wide tape @ a 60mm pitch to be used on a Universal GSM. | It is not a standard tractor feed, so it would require quite a bit of ingenuity. | Does anyone out there know of someone who designs and bui
Electronics Forum | Mon Mar 15 15:52:38 EST 1999 | Earl Moon
| After switching from No-clean flux to Water soluble (Kester)we encountered voids problem (X-ray and microsectioning). Reducing the apperture sizes made the voids smaller but did not eliminate them. So we had to go back to No-clean. Any idea why voi
Electronics Forum | Mon Mar 15 16:01:06 EST 1999 | Earl Moon
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Wed Mar 17 12:19:53 EST 1999 | Scott Cook
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Tue Mar 16 07:42:07 EST 1999 | Ben Kirk
| | Here is my question. We have several fuji CP's in our shop, every once in a while the first couple of parts placed are off the pads. When we move the parts further down in the sequence they are fine. What is going on? Has anyone had this problem
Electronics Forum | Thu Jun 03 01:33:40 EDT 1999 | Bubba
| Here is my question. We have several fuji CP's in our shop, every once in a while the first couple of parts placed are off the pads. When we move the parts further down in the sequence they are fine. What is going on? Has anyone had this problem an
Electronics Forum | Fri Mar 12 15:23:06 EST 1999 | Steve Schrader
| SMTNetters: excellent Forum, keep up the good work all! | | We are in the process of purchasing a Dek Stencil Cleaner and we have been recommended to use Vigon SC200 solvent to remove Heraeus no-clean solder paste from stencils and mis-printed PCB
Electronics Forum | Fri Mar 12 17:59:29 EST 1999 | Bill Schreiber
| | SMTNetters: excellent Forum, keep up the good work all! | | | | We are in the process of purchasing a Dek Stencil Cleaner and we have been recommended to use Vigon SC200 solvent to remove Heraeus no-clean solder paste from stencils and mis-print
Electronics Forum | Fri Mar 12 18:12:15 EST 1999 | B. Walton
Spray cleaners are poor alternatives to todays ultrasonic stencil cleaners. Ultrasonics are the way to go and you can use rather benign water based chemistries to get the job done. As for screening adhesives and cleaning glue residue with spray wands
Electronics Forum | Tue Oct 12 17:09:25 EDT 1999 | Kevin Ham
Scott: Call me I will send you a sample of our Cleaning Detergent. Kevin Ham PMR Systems, Inc. 480-829-8170 ext. 11 | SMTNetters: excellent Forum, keep up the good work all! | | We are in the process of purchasing a Dek Stencil Cleaner and we