Electronics Forum | Tue Mar 26 06:07:58 EDT 2019 | pooja_4t
Hi i am referring Tin whisker report JESD201A class 2 standard from Vishay. i can see at TC -55/85C using pbfree reflow there are 0 growth at 500&1000 cycles. for snpb reflow and the same temperature and same cycle significant growth can be found. my
Electronics Forum | Thu Mar 28 20:40:35 EDT 2019 | sarason
I built myself a reflow oven using an off the shelf 29l fan forced oven with digital controls. I then fully insulated the cavity around it with kiln fibreglass, and added a metal infill at the back as the back of the oven was just a metal sheet. Anyw
Electronics Forum | Fri Mar 29 11:02:04 EDT 2019 | robl
Not sure it's always a great route as the smaller ovens are going to struggle to get a perfect profile for a consistent result, especially on bigger boards with higher layer counts and mixed technology. You may want to take a quick look at a batch va
Electronics Forum | Fri Mar 29 11:46:13 EDT 2019 | emeto
I have used the Chinese ovens that Manncorp is selling bought from another supplier and they can do the job. These will do the job. You can manufacture metal piece(plate) slightly tilted to collect the boards behind the oven(similar to wave soldering
Electronics Forum | Fri Mar 29 15:43:26 EDT 2019 | tjs1634
We handle a similar SMTA quantity in house and use a 5 zone SMTmax AE-F530C 220V Single Phase Equipment Outline Size L-2000* W-612* H1220 mm Heat Zone Length 1000mm Equipment Weight 180kg Max power 7kW Belt Width 300 mm PCB Size 280x280 mm Comp
Electronics Forum | Fri Mar 29 20:07:50 EDT 2019 | sarason
I measured the temperature rise when I built the unit and it has a nice linear rise in temperature over the 3 minutes. I have used the Quikees before. The galcon gas stinks and must be evacuated. The galcon is expensive. The galcon is a perflourocar
Electronics Forum | Mon May 13 03:01:23 EDT 2019 | peterchan
Hello, sir. We are a SMT equipment manufacturer from China. We have a hot-press soldering machine that can change your current situation of manual soldering on PCB board. In addition, we have a better reflow oven, the upper and lower two cold tempe
Electronics Forum | Mon May 13 03:12:47 EDT 2019 | reckless
For your operation you may want to consider this depending on the kind of boards you are doing. https://neodenusa.com/smt-reflow-ovens/neoden-in6 110V 3 Zone Smart Reflow Oven Neoden I don't think china ovens are truly industrial grade but you may
Electronics Forum | Wed Mar 27 12:17:46 EDT 2019 | jstebbs89
Hello lads. I run a Sequencer 2596 and have had good luck. Just recently it sounds like air is not making it into the machine. With the machine palmed down it has the required 55-60psi going in, when I release the Estop the psi drops to about 30 and
Electronics Forum | Wed Mar 27 13:47:24 EDT 2019 | whitelancer64
I am having an issue with aligning vision for solder paste inspection with the PCB in the Momentum machine. The SMT operators setup the profile on the machine, which I then import into Aegis CircuitCAM to add PCB locations. But when I export again, t