Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Sat Apr 21 04:39:45 EDT 2012 | brotakul
I am using different equipements for SPI such as Koh Young and Cyber Optics machines. I am looking for implementing a general procedure (SWP) for setting LSL's and USL's on the products on which the customer does not specify any limits on the solder
Electronics Forum | Fri Jun 01 10:52:37 EDT 2012 | blnorman
Neither the Omega meter nor the IC are officially "destructive" tests, but everywhere I worked we treated them that way. The boards were scrapped after the test. The Omega meter can be tested at elevated temps, but the IC sample is extracted at ele
Electronics Forum | Mon May 14 12:44:08 EDT 2012 | tomgervascio
I am a user of an Ersa Versaflow 3/45. I was wondering if anyone could share some process pointers. I have a 0.125" multilayer PCB that I am having problems consistently achieving 75 percent hole fill on a mini-coax connector. The coax connector ha
Electronics Forum | Wed Jun 20 12:16:59 EDT 2012 | allgood
Hi John Yes I am still having the same problems years later! It keeps Fred in work supplying me with replacement tips too! Mydata came up with a supposed fix to alter a parameter called prepick which puts a pause in I think allowing the head to st
Electronics Forum | Tue Jun 12 11:10:08 EDT 2012 | dyoungquist
We run 1 high mix/low volume line using a MY12 with the MyLabel and MyPlan software. The MyLabel software helps reduce setup times while tracking quantities on the reels and is well worth the investment in our opinion. As for needing extra reels on
Electronics Forum | Wed Mar 20 09:59:10 EDT 2013 | mainenetservices
Regarding the software part of this thread, one of our long time forum supporters has a product that also may be helpful - Rich Larue from Unisoft says, "It looks like ANTON99 is looking for is a BOM comparison across multiple assemblies to ID like
Electronics Forum | Mon Sep 01 21:26:51 EDT 2014 | proy
We are a smaller company and have created our own systems using FilemakerPro, and it grows and evolves with us as we constantly improve it. Filemaker is a complete relational database system wrapped up WITH the tools to create your user interface -
Electronics Forum | Wed Jul 04 09:58:50 EDT 2012 | daxman
Assuming that you have a saturated moisture-sensitive component: At what temperature would popcorning or internal component damage occur? I would guess that it would be at a temperature where water would boil, around 100 degrees? However, the JEDEC J
Electronics Forum | Sat Aug 18 00:49:56 EDT 2012 | audere
When I see this on my QSP2 it is always caused by the nozzle not seating ideally but I tend to set my tolerances really tight. To test mount a nozzle and look at Z height. Now pick up the part (which in my case will suck the nozzle upward due to the
