Electronics Forum | Wed Oct 08 12:49:37 EDT 2008 | leemeyer
When in the fiducial teach screen check to see if the "Fiducial Data from Autoprogram" box is checked. If this program was not generated from Autoprogram this box should not be checked.
Electronics Forum | Wed Oct 08 13:30:04 EDT 2008 | bobpan
You need to check and see what you have 'y' set to in teach fiducials. Make sure you have only 1 with a 'y'(panel or multi-image fids)....then teach the appropriate one.
Electronics Forum | Wed Oct 08 14:20:34 EDT 2008 | sambolian
I only have 'Y' in the "Global Fiducial Correction" box , but it still gives me the error of "Fiducials not taught". Any more suggestions?
Electronics Forum | Wed Oct 08 14:30:42 EDT 2008 | leemeyer
Was the board programmed using Autoprogram or did you hand program it? What version of Central Controller are you running.
Electronics Forum | Wed Oct 08 15:46:41 EDT 2008 | bobpan
ok....couple of other questions first......does your machine say MVS when entering into central controller? After you teach your fiducials...Are you entering out of the screen....if you hit escape it doesnt save what you have done.
Electronics Forum | Wed Oct 08 16:31:44 EDT 2008 | sambolian
Yes, it does says "Sending MSG to MVS" and yes, I am entering out of the teach screen.
Electronics Forum | Tue Oct 21 12:10:04 EDT 2008 | jdumont
Do your boards only have three parts on them? Otherwise, i dont see how this is possible. Do you scrap the board if there is an issue or do you fix it and make it look like reflow soldering?
Electronics Forum | Thu Nov 13 04:00:35 EST 2008 | phomann
Hi Dave, Thanks for the reply. I'm trying that but not with a lot of success. Cheers, Peter.
Electronics Forum | Mon Nov 10 07:22:42 EST 2008 | janz
Hello, I am looking for operation& service manual for reflow oven BTU VIP98 with air cooling and nitrogen. Thank you for any help. janz
Electronics Forum | Tue Nov 25 10:11:25 EST 2008 | slthomas
What are you currently using to store boards in between processes and/or work stations, and during manual assembly (assuming there is some)?