Electronics Forum | Thu Jun 06 13:50:03 EDT 2024 | SMTA-64386699
If you still needed I might be able to help out.
Electronics Forum | Thu Jun 06 14:30:05 EDT 2024 | stipton
Yes please, that would be greatly appreciated!
Electronics Forum | Thu Jun 06 16:24:09 EDT 2024 | mistrthou
Were you not able to get what you needed out of my file?
Electronics Forum | Wed Apr 04 19:27:07 EDT 2007 | davef
The easiest, long term cheapest, and most accurate way to measure top-side temperature is to use one like: * http://www.amazon.com/Fluke-62-Mini-Infrared-Thermometer/dp/B000MX5Y9C/ref=pd_sbs_auto_2/102-7460227-1828165 * http://www.amazon.com/gp/prod
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Tue Mar 01 23:55:41 EST 2011 | cmguan79
Hi all, Need help troubleshooting for I've just bought a 1997 second-hand oven HVC102. Unfortunately, after loading profile & press run mode we found all TC READING IS ZERO & CONVEYOR READING FEEDBACK IS ZERO SHOWN ON MONITOR SCREEN ,& I LOSS PA
Electronics Forum | Tue Jan 20 04:43:33 EST 2015 | gragal
I need to replace a device which is in a 6-pin package which looks like SOT 23-6 / SC-74 style. The markings are D102/ 214B (D102 above 214B). I have checked numerous references to no avail. I think that the device is a comparator or op-amp with V
Electronics Forum | Fri Jul 07 12:44:49 EDT 2017 | tsauve
The problem is registration between the stencil & the smallest pads on the 5 substrates. Using SPI s/w I can overlay the paste layer over the PCB image to determine stretch/shrink. Our worst case was shrinkage of 10.2mil on a 5-up 300mm panel - small
Electronics Forum | Wed Jan 17 08:41:07 EST 2024 | spoiltforchoice
The neat and simple solution is indeed a laser. However I have seen other quirky ways to denote a build revision. These include a resistor with a value marking that matches the build revision e.g a 1K marked 102 could indicate assembly 1.02. Another
Electronics Forum | Mon Apr 20 08:34:20 EDT 1998 | Chris Fontaine
We use a Seimens MS-102 and have found the techcical support offered by Seimens for this machine to be nearly non-existant.
.gif)
winsouce.jpg)