Electronics Forum | Wed Feb 14 02:38:13 EST 2007 | Wayne
The middle of the BGA has to make sure it has 235 deg C (if you are using SAC paste), otherwise it will not form good joint.
Electronics Forum | Wed Jun 27 10:44:09 EDT 2007 | bjrap3
What would a good ramp rate be. I am running from 205-217C in 17 seconds. My reflow is 217-235 for 68 seconds. The bottom preheaters are set at 200C and the nozzle is 2075 & 295 for each process respectively.
Electronics Forum | Fri Sep 05 04:21:37 EDT 2008 | aj
Hi all, If you are profiling a pcb that has a wide variety of comonpenents with varying temperature sensitivity requirements what do you do? e.g. 1136 ball BGA with min reflow temp 245 with tsop48 with max reflow temp 235 etc. rgd's aj
Electronics Forum | Thu Apr 09 09:23:29 EDT 2009 | ed_faranda
Well, I did manage to solve this problem. I lowered the max boards temp from 245 to 235. Then I decreased my TAL. This seemed to work perfectly. Thanks everyone for your suggestions! They got me in the right direction.
Electronics Forum | Tue Dec 15 06:07:53 EST 2009 | joelinacio
I need to know what is the sot-23-5 in the dmm fluke 189 with the code t6g. It is wired with the com conector.
Electronics Forum | Mon May 02 14:01:26 EDT 2016 | russwa
Hello Ermani, I am the support manager for ViTECHNOLOGY in the Americas and we can provide you any assistance you may need. Give me a call in our office at 972-235-1170 so that we can discuss your specific needs. Russ Warncke
Electronics Forum | Mon May 08 10:10:27 EDT 2017 | dontfeedphils
For anyone looking this up in the future, I ended up settling on part number "A-2-3.5", an aluminum, smooth finish coupon, 0.025" thick x 2" x 3.5".
Electronics Forum | Thu Oct 03 11:23:50 EDT 2019 | bukas
hello, i have a faulty board with SOT-23-5 component on it marked APKK. excluded everything else. does anyone know what component this may be? I cant find it online...
Electronics Forum | Mon Oct 18 22:15:11 EDT 2004 | KEN
I have two industry leading customers that have specific requirements for components to survive 30 seconds above 230C. In one case I have a custom ASIC that is heat sinked on the die (to the PCB). The sink pulls heat out of the lead frame very effi
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
