Electronics Forum | Mon Oct 18 14:31:01 EDT 2021 | charliedci
We recently purchased a Scienscope AXC-800 III which can count 4 7" reels at one time in seconds. It can count tubes, trays and bulk as long as keep the components down to 1 layer (which for bulk is not ideal). so far we are very happy with, cuts dai
Electronics Forum | Thu Jan 06 01:55:01 EST 2000 | Roni Haviv
From my experience: It's depends on your messurment tools and the component: - Average high (at least 3 messurment points) should be 6 mils max. (you'll always get pick points of 4-7 mils!). - It depends on component tech./pitch: in pitches great
Electronics Forum | Mon Jul 01 16:45:31 EDT 2002 | pjc
Yeah, you'll get the blue button functionality w/ 1.6. That protects the machine by disabling the magazine before its pulled from the machine. It tells the computer not to pick from that mag. Going from 1.4.7 is the same as going from 1.5, just softw
Electronics Forum | Tue Jun 26 21:41:10 EDT 2007 | davef
4.4 Determine the amount of flux on the board. 4.4.1 Get a piece of corrugated cardboard and a weighing scale accurate to 0.01 grams. NOTE: Use cardboard with alcohol fluxes to slow their evaporation and get good data. 4.4.2 Weigh the cardboard. 4.4
Electronics Forum | Fri May 26 04:58:19 EDT 2023 | auriga2001
I agree with the two other replies. Left alone, it is a defect. If it's just excess adhesive or coating, you can use IPC-7711/7721 'Rework, Modification and Repair of Electronic Assemblies' for guidance on removing. Section 2.3.1 explains how to te
Electronics Forum | Tue Jan 12 08:06:43 EST 2010 | kpm135
basically the rule of thumb for the 8mm feeder is that you only want one component exposed in the pocket at a time. If you see more than one component exposed you need to go down in size. The reason for this is that if there is another component expo
Electronics Forum | Thu Jul 20 12:44:21 EDT 2000 | Ketan Bhatt
We have difficulty in placing a trimmer capacitor chip using our Philips CSM 84 VIII pick and place machine. This Trimmer capacitor is supplied by Murata and its partno is TZBX4P300BA110T00 and value is 4.7~30 pf. While trying to place the componen
Electronics Forum | Fri Jun 12 11:54:55 EDT 1998 | Rin Or
| I am currently in the process of trying to justify new equipment in my factory. I currently have Siemens siplace 15 series machines. I don't feel thins equipment is right for high mix/ medium to low Volume. I am running up against a in house con
Electronics Forum | Tue Jun 25 15:30:49 EDT 2002 | Steve L
Hi everyone. I am now faced with a problem on soldering PBGA. At first, I ran the board (FR4, 7" X 10" with 12 layer) at Peak Temp: 205 C and 54 seconds above 183 C. After reflow, I found several cold solder joints and one ball without second collaps
Electronics Forum | Fri Dec 09 05:03:35 EST 2005 | rlackey
Hi, I'd be inclined to go with the through hole capacitor, as to surface mount it you would probably need to go for an elco (ceramics & films don't do that value in that voltage, & you'd be hard pressed to get a tant in that voltage). SMD Elcos a