Electronics Forum | Mon Jul 09 11:52:21 EDT 2012 | bobpan
Does it show the ANC in a position on the feeder base in the screen that has the nozzles/hole positions? When you go to optimize ...there is a screen that has something to do with registered ANC.....There could be something there that is incorrect. I
Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
Electronics Forum | Fri Jun 23 12:38:49 EDT 2017 | jamesn
Hello Please can someone help with a feeder Base Issue I get the message " Warning Base Manager 2 Runtime '7e' Error Wrong Message Parameter " I have swapped the removable bases 1 & 2 over but the fault still lies with base manager 2 I will than
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Tue Mar 08 23:02:18 EST 2016 | dekhead
If it is a Vortex Cassette error, that is based on "Cassette Life" Programmed into Product file. Maybe erroneous software setting.
Electronics Forum | Tue Sep 20 13:37:00 EDT 2005 | jasont
We have x30 PPU's across x3 FCM Base 1's which are not working properly (error is "image too low"??). Please advise on how to repair/replace these (besides Assembleon themselves). Thanks in advance, Jason
Electronics Forum | Tue Oct 05 16:38:51 EDT 2010 | tskim83
Our hole inspector gives this error message “Base Hole Error”. It is a flat conveyor-type hole inspection machine from YAYATech that scans PCBs, with an optic sensor and cameras on top of the belt and a light source on the bottom of the belt. And dur
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom