Electronics Forum | Mon Jul 10 13:08:21 EDT 2023 | ttheis
Thanks, I do recall reading about loading firmware onto some of the VME cards (VRM axis controllers I believe.) I will review this again. I agree that it seems to be some issue with reading axis position after hitting the home switch. The first thin
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Wed Mar 03 14:25:02 EST 2021 | astarotf
Hi Spoiltforchoice Thanks for the comment. With the line encoder readers that the machine brings, we performed a positioning reading check, which showed us the increase or decrease in the path that the heads make, with which we conclude that it is re
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Tue Nov 01 14:40:22 EDT 2022 | glasscake
Also to diagnose if it is the correct axis go to the "calisim" or the "axis position" option in utilities and get to the "current position" menu. Estop the machine and move the relevant axis by hand and see if the encoder count goes up.
Electronics Forum | Sat Feb 16 11:36:09 EST 2019 | robertorocco
When the camera moves to the bord stop position, or to the fiducial position, the following message appears "Axis camera error - out of time" some indication on how to solve the problem? Thanks
Electronics Forum | Thu Jun 02 15:16:54 EDT 2016 | dilogic
I did try to null the axis - no improvement. I have AMC software and tried (almost) everything related to electronics (except for changing linear encoders, but this seems to be OK - when I move axis manually, position numbers change smoothly). It loo
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
