Electronics Forum | Tue Nov 22 17:08:03 EST 2011 | mikenagle
I am looking for process suggestions. We want to use a pin transfer system to deposit adhesive to hold bottom side SMD's in place. We will place SMD's and through hole power parts on the top side and then run through a wave solder machine. Are ther
Electronics Forum | Wed Nov 23 07:30:44 EST 2011 | scottp
Are you stuck with pin transfer for some reason? Screen printing is more repeatable and easier to maintain.
Electronics Forum | Wed Nov 23 07:38:49 EST 2011 | davef
We agree with the points made by ScottE above. Additionally, most printers are not heavily loaded. So, you wouldn't have to buy another machine, give-up floor space, purchase and store peculiar tooling, etc. We think Darby does pin transfer. Maybe h
Electronics Forum | Wed Nov 23 09:38:52 EST 2011 | blnorman
More agreement with screen print adhesives. Back in a former life time we did do pin transfer on one of our product lines. If you had to go with pins, make sure your adhesive rheology is suited for it. Different adhesives are designed for specific
Electronics Forum | Thu Nov 16 08:57:00 EST 2017 | jandon
We found used Ersa HotFlow 2/14 reflow oven that does not have bottom side preheaters. Can it be easily and safely used in normal high mix/low volume production or is it built for specific products which does not need bottom preheaters?
Electronics Forum | Tue Nov 27 06:11:42 EST 2007 | shy
Hi Loco, my PCBA got top side and bottom side and 90% SMT and 10% THP (top side) which need to be cover by wave solder. And that's why i need to go through reflow and wave.
Electronics Forum | Tue Nov 27 07:36:29 EST 2007 | shy
solder the part is for SMT component (located at top side and bottom side) and wave solder is for THP (located at top side only).
Electronics Forum | Tue Dec 09 12:26:45 EST 2008 | greene08
I have virtualy no experience with placing bottom side components. We have a new board coming that will have a few R's & C's bottom side. Can anyone give oppinion on dispensing glue dots vs. applying adheasive with a stencil ? thanks
Electronics Forum | Sun Dec 02 22:00:21 EST 2007 | shy
The idea for solder at bottom side is for component such as SOIC, QFP and chip. This solder is needed since not entire bottom component had glue. that's why we're combining both solder paste and glue and reflow at the same time.
Electronics Forum | Tue May 07 22:25:15 EDT 2002 | L_ch
Hello, As you know for the double side assembly PCBs, we normally first place the bottom side, then place top side after reflow soldering of bottom side. are there any other considerations for the sequence of reflow soldering ( bottoms side first, to
