Electronics Forum | Fri Aug 07 11:02:29 EDT 2015 | ehess
Can Assembleon Opal nozzles be repaired? I have a few ith chips on the corners of the tips. It appears as though the tips are pinned in the bodies of the nozzles, and that they could be changed out. Thanks
Electronics Forum | Wed Jan 28 15:35:47 EST 1998 | Tommy Turner
| We have some trouble adding a IC head Nozzle to a | Siemens Siplace machine. | It seems like the machine don't want to recieve | new MA data, coz even if we restart the line | the old nozzle configuration will be used. | Anyone know what we do wron
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Mon Jul 09 15:34:40 EDT 2007 | dilogic
Yep, I've learned the lesson the hard way - you can't start GSM with no nozzles on heads ;-). I've discovered after I posted the question. Thanks anyway... - Deni
Electronics Forum | Sun Jul 08 06:38:41 EDT 2007 | dilogic
We have an old GSM1 (I-block, USOS V1.4.14, two 4-spindle heads, changers between rails). When I configure machine so there are no nozzles on heads and changers are filled with required nozzles, except for one empty hole, machine won't pick up nozzle
Electronics Forum | Mon Jul 09 11:19:07 EDT 2007 | swag
I could be wrong but I don't believe that you can start with any empty spindles. If it picks up nozzles, you will end up with more than one empty changer hole which will not work for the vacuum that is required to remove the nozzles from the spindle
Electronics Forum | Sat Jul 24 04:02:18 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch
Electronics Forum | Sat Jul 24 04:02:21 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch
Electronics Forum | Wed May 23 20:33:51 EDT 2012 | stentech
Great information guys..I am learning a lot. Reading all the info changing the nozzles, pressure and coatings are certainly narrowing the choices. A lot of coatings I have come accross seem to come from the Mould industry especially Teflons etc. I lo
