Electronics Forum | Mon Mar 03 13:18:02 EST 2003 | msivigny
Hello phil, The use of AOI systems give us the opportunity to auto-collect defect information much the way you're using them now. AOI systems become extremely effective when the collected data is used to perform some positive change into the process.
Electronics Forum | Thu Apr 05 13:11:03 EDT 2007 | dphilbrick
Siemens with minor adjustments. I believe they even have a retro to go to 26" on some machines.
Electronics Forum | Wed Feb 01 08:18:28 EST 2006 | slaine
RS sell a heat cun that is fully temperature adjustable buy one of them and pre set it to the right temp then put a calibration sticker over the control.
Electronics Forum | Wed Mar 08 10:59:04 EST 2006 | samir
Cal, thanks for the feedback. I've tried different adjustments to wave parameters with varying success. You know how wave is - what works today won't necessarily work tomorrow. ..and yes, we run Nitrogen on our waves.
Electronics Forum | Sat Apr 14 10:21:30 EDT 2007 | HOSS
We are processing a 5x22" PCB using Juki "2010E and 2060E". Machines are spec'd as 18x20" cabable. We just needed to adjust a conveyor sensor (1 time) and ignore a few placement area warnings.
Electronics Forum | Thu Oct 30 12:26:26 EDT 2008 | slthomas
Your fridges can't be temperature adjusted? We've always just used "pre-owned" kitchen fridges and set them where we want them.
Electronics Forum | Wed Mar 31 04:43:52 EDT 2010 | accuspares
If you dissconnect the crash beam sensor one at a time at the front leaving the remaining one connected you’ll be able to identify what side is causing the problem. Then you will be able to hopefully remove the object or adjust the position of the be
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Mon Aug 24 03:59:26 EDT 2009 | hurr
Hallo Joanne, I had employed by producer of Ecofrec 303. We make many tests of corrosion and conductive test in our company. All results of this tests was OK . Vast majority correspond mil standarts. When I ask my labor assistent in BRY, white residu
Electronics Forum | Sun Feb 13 16:28:00 EST 2011 | tpappano
Does nozzle #1 lower at all when it should pick up a part or is it just staying in the fully up position? If it does come down, but not quite far enough to contact the part, there are adjusting nuts on top of the head that set the lower limit for no