Electronics Forum | Tue Aug 28 11:03:40 EDT 2012 | mikesewell
The problem is still intermittent. It has a new MIDAS head, installed and calibrated by Mydata, FWIW. Usually we work around it by moving parts upstream (Fuji AIM). I'll post an update when I finally chase the issue down.
Electronics Forum | Mon Jul 16 16:28:18 EDT 2012 | mikesewell
I'm somewhat frazzled by this one, not being too familiar with the MYs. Head is clean, tried different tools, same tool# from another MY, and have run the Centering Base Level Calibration to no avail. The component heights are correct and the par
Electronics Forum | Mon Jul 16 13:54:53 EDT 2012 | markhoch
It's been a while since my MYDATA days, but let's give this a shot. Did you try putting the tool away and picking it back up? Make sure your Midas Head is cleaned and the tool is lubricated properly, then do a Center Base Leveling Calibration. (I t
Electronics Forum | Tue Jul 17 09:10:28 EDT 2012 | dontfeedphils
You can enter the service program for the MyData, can't remember exactly how, you have to exit out of tpsys to the command prompt and type service or something along those lines. Then you can check the raw numbers for vacuum and force on the Midas h
Electronics Forum | Tue Jul 17 10:09:48 EDT 2012 | cyber_wolf
Phil is on the right track. Try this.... Go into the service program, and bring up the vacuum force indicators. Manually install a spring loaded tool into the Midas head. Once the tool is in the head, press on the tip of the nozzle with your finger.
Electronics Forum | Mon Aug 27 08:37:13 EDT 2012 | rgduval
If you're still having this problem, talk to Al at MyData about replacing the ribbon cable that is wrapped inside the head, and connected to the two LED's. It's a bit of a pain to replace this cable, but, it did fix the problem for us. The other po
Electronics Forum | Fri Sep 07 17:03:10 EDT 2012 | burb1999
I would guess the FFX cable as metioned with the sensors inside the midas, that could of been damaged by a part or? Not a big deal to replace just remember how many turns the milar harness goes around. Also just loosen the rear screw there is a slo
Electronics Forum | Wed Sep 18 15:40:12 EDT 2013 | pankalaitz
Hello, we have problem with indicator. When we manually install a spring loaded tool into the Midas head, the force remain at 180. We can't use spring tools. Can you advise me how can we calibrate the force indicator and what else should I try to fix
Electronics Forum | Thu Sep 19 10:27:10 EDT 2013 | rgduval
I believe there is a force calibration menu option in the maintenance menu. From the main screen, choose exit to maintenance to get into the maintenance menus. If you're still having force issues afterwards, you'll want to start hunting for broke
Electronics Forum | Wed Jul 17 02:31:30 EDT 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem.After hardware initiation appear F-MOT-MSETDYN conveyor transport/1250: amplifier DC-link too high.Any suggestions? Thanks
.gif)
