Electronics Forum | Sun Nov 22 10:05:37 EST 1998 | Christopher Lampron
| Does any body know stencil manufacturer in states or south east asia for electroforming processes and step down from 5mil to 3mil. | | Thanks! | Daniel, I do alot of work with Photoetch stencils in Massaschusetts. I do not have the Phone number h
Electronics Forum | Thu Feb 12 12:03:02 EST 2004 | pjc
The reality is mfg jobs worldwide are going down down down. In fact Asia lost way more mfg jobs - in terms of numbers, not percentage - than NA and Euro. The fact of the matter is less and less people are needed to make more and more products. Pretty
Electronics Forum | Fri Apr 08 00:28:34 EDT 2011 | Jacki
We use 7mil stencil to print Epxoy by using printing machine. Not all Tant from the same reel fell down. Some Ok but some misaligh. So, we concluded that Tants with higher terminal fell down while the Tants with lower terminal were fine. I dun say
Electronics Forum | Thu Mar 28 09:43:19 EDT 2019 | dekhead
Pneumatic power down error does go back to MMX12. MM's info is communicated to NM (in PC enclosure) via 100 way cable. Depending on software version, the "Pneumatic Power Down" error may be the default (initial) error generated with bad connection /
Electronics Forum | Tue Feb 11 04:08:51 EST 2020 | majdi4
we have a problem : The connector is falling down in the second reflow. This connector is mounted in the first side. You can find attached the reflow profil we work with and a photo of the connector. We tryed with under_film but the connector is sti
Electronics Forum | Mon Apr 18 12:06:03 EDT 2022 | dsmith
During the initialization process, the table will make small movements up and down, and occasionally go all the way up and back down again, then continue to bounce up and down maybe an inch of travel, it never completes initializing. I wasn't operati
Electronics Forum | Wed May 11 11:21:11 EDT 2005 | russ
Been getting wacked by lightning for twenty years in this business. (three times yesterday as a matter of fact) We have never shut down in anticipation that we are going to get hit. I have lost one motherboard in all of these years that cost about $
Electronics Forum | Sun Feb 13 18:47:21 EST 2011 | gabriel1blue
Thank you for your fast reply, head 1 moves to the pick up location and stays up, then it moves to the dump location and moves down to drop the part, it was running before just the offsets where off (moving up and down). If I chance the head from hea
Electronics Forum | Wed Jun 11 16:52:17 EDT 2014 | aybars
yes, you should look to see on that particular feeders Z axis setting. When the tip goes down to the part it may be traveling down little too much. Just make sure you check which way is your - and + increments going and do not exceed more than 30 or