Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Nov 10 23:09:45 EST 2005 | davef
Poured flooring suppliers are: * Garland Floor http://www.garlandfloor.com * Sauereisen http://www.sauereisen.com/c_prod/c_esd.htm Vinyl & rubber flooring suppliers are: * VPI http://www.vpiflooring.com/products.php?cat=2⊂=1 * 3M http://products3
Electronics Forum | Mon Apr 19 21:37:17 EDT 2021 | ouaret
dear all, update: we got that the calibration of SIM is the problem, the distance between SIMs need to be calibrated. can someone help us get the manual that describe on how to calibrate the SIMs? we have a problem with our cyberoptics AOI machine
Electronics Forum | Tue Jun 17 07:17:09 EDT 2003 | James
The main problem I am having is getting the Rising slope 1-3 degrees. If I slow the conveyor down then I have too long of a reflow and if I speed it up then my ramp rate is too high. I was not sure if I need my first zones at a low temp or higher t
Electronics Forum | Mon Dec 28 09:12:56 EST 2009 | kpm135
@tommyg_fla According to the TDS the recommended coating thickness for Humiseal 1B31 is only 1-3 mils so if I had to guess I would say your issue might be that you're re-coating over the first pass too soon. All the solvent hasn't evaporated and the