Electronics Forum | Tue Mar 03 13:40:44 EST 2020 | tomdegas
I swapped out the cable with no luck. The Hydra Z controller is the board on the right side of the Hydra head with everything plugged into it right?
Electronics Forum | Tue Dec 06 18:35:21 EST 2022 | cyber_wolf
Sounds like the Hydra is disabled in settings. One of the Micronic experts will have to tell you where that is.. My last Hydra was a MY12 many years ago.
Electronics Forum | Mon May 08 18:13:59 EDT 2023 | joekirin
Do you have an optical centering phase active for centering? You can have hydra tools setup in the package but if there is no optical centering it wont use the hydra.
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Sun May 07 16:55:27 EDT 2023 | rw
There are times where even if you have the tools on the hydra, they are assigned to the package, and the hydra is active, the machines algorithms will determine if the single mount is faster or easier depending on density of the design. Parameters
Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t