Electronics Forum | Thu May 13 11:25:02 EDT 2021 | rsikora
Thanks for the replies. MCS is not on our 3030, it probably wasn't available on the 3030 model. The ethernet switch which connects the vision pc and the rtpc was found to be defective. The switch was replaced and the 3030 returned to normal operat
Electronics Forum | Fri May 07 21:31:52 EDT 2021 | sosigguy
Have you checked WinMCS? it's the software in windows that controls the machine. if you open it up it might have thrown some error codes, i believe it has some diagnostics in it aswell.
Electronics Forum | Mon May 10 12:04:50 EDT 2021 | rsikora
Thanks for your reply. I haven't checked or used WinMCS for troubleshooting. Based on your reply, I looked or WinMCS within Explorer and could not find it. Used the autosearch function for "MCS" and "WinMCS" and the autosearch did not find it eith
Electronics Forum | Mon Jan 09 16:04:45 EST 2023 | proy
We have a Koh Young 3030 3D SPI machine - this was completely working and we shipped it out to storage, and brought it back. Presently now though - the Machine controller computer which is a Unix machine has a corrupted disk drive. The Windows comp
Electronics Forum | Tue Oct 22 14:43:20 EDT 2019 | kathylci
Looking for someone to speak with regarding a Koh Young 3030VAL. Want to find out some information on the ease of programming for this unit. Any help is greatly appreciated! Thanks- Kathy
Electronics Forum | Sat Nov 09 14:15:18 EST 2019 | linux
Perhaps I can help you out, have experience with kohyoung Spi and AOI
Electronics Forum | Thu Mar 24 23:41:40 EDT 2022 | glasscake
Another oddity, when I unplug the PCI1/2 cables and cycle power I still get the same error.
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
Electronics Forum | Thu Feb 14 03:49:56 EST 2019 | dimamalin
Thank you , it going to be very useful
.gif)
winsouce.jpg)