Electronics Forum | Wed Jul 15 12:43:35 EDT 2009 | thanhnguyen
check your vacuum valve, manually turn it on and off,i have the same problem like that b-4, after replacing the vacuum valve, the problem went away.
Electronics Forum | Wed Jul 15 12:44:11 EDT 2009 | thanhnguyen
The Tant size is 3528-21. I use type 72 nozzle > for it. check your vacuum valve, manually turn it on and off,i have the same problem like that b-4, after replacing the vacuum valve, the problem went away.
Electronics Forum | Mon Jul 13 13:48:37 EDT 2009 | christian01976
Hello! You can check your vacuum in MANUAL and then VACUUM IN MONITOR. You can switch the vacuum on or off for each head. With a TYPE 72 nozzle and no component the vacuum should be around 80 or 90 and with a component at the nozzle it should be ove
Electronics Forum | Mon Jul 13 11:34:44 EDT 2009 | snsmt
thanks everyone! When we have a PCB to do, for one component, they usually give us an excess of 10 components! We are issued over 2,000 components. Does that sound reasonable? The problem is usually when the head picks up the component before it r
Electronics Forum | Tue Jul 14 13:45:04 EDT 2009 | christian01976
Hello! You could check your pick an mount vacuum, too. You can do it in COMPONENT INFO with the ADJUST ASSISTANT (F6). Then PICK UP COMPONENT. If you don´t know how to read the grafic that is shown then just push F1 for HELP. What size do the TANT h
Electronics Forum | Sun Mar 04 07:48:50 EST 2012 | dilogic
Are you sure that the parts are bouncing? We had similar problem where diodes were placed very closely and occasionally nozzle pushed already placed part away (due to pick-up tolerance)...
Electronics Forum | Sun Mar 04 09:53:00 EST 2012 | eadthem
What i have on the original 2 problem boards is the parts next to it are SOIC8 and placed using a 125F(.125" dia) 1 of witch is close and we have to Z zone it to place the SOIC last, the others have more than .02" clearance on all sides. The other
Electronics Forum | Sun Mar 04 01:56:37 EST 2012 | eadthem
What we have had recently is a lot of larger thin (32 thou) thickness boards that have had issues with SC90 diodes bouncing off the pads in the final PNP machine. Our setup, universal instruments GC120 or quad beam 30 spindle lightning heads. This m
Electronics Forum | Wed May 31 22:17:24 EDT 2006 | EC
Hi Jack, I do not know what type of machine you are using and how old is your machine. But I have this problem before using Fuji machine. There are few things cause part throw.....placment speed, feeder, pick up tolerance, part dimension tolerance,
Electronics Forum | Tue Oct 12 10:24:22 EDT 2004 | sdsmt
i worked with cp6s in 1995 and 1996. we always had missing part problems that was machine related. we had to inspect every board for missing parts. it was a disaster, imho, but i expect a chipshooter to consistently load chips. otherwise, it was