Electronics Forum | Tue Mar 17 10:24:42 EDT 2015 | chemers
They are the older TM type. The belts are whole and rollers move, it just doesn't move enough to pull the tape reliably. Thanks.
Electronics Forum | Tue Mar 17 12:48:41 EDT 2015 | cyber_wolf
Couple things: If the rubber roller that touches the take up wheels is worn you can adjust it. The axle is on an eccentric. Make sure the "teddy bear faces" that adjust the pick point are not grossly different from the left to right sides of the ma
Electronics Forum | Wed Mar 18 09:52:40 EDT 2015 | rgduval
You'll want to double check the electronics in the magazines, as well as the mechanicals. Over time, the connectors can come loose, and could affect performance. I'm thinking of the "dead" feeder that you mentioned, while the rest of the feeders wo
Electronics Forum | Thu Feb 10 14:27:07 EST 2005 | cyber_wolf
First of all, whom are you getting it from ? Mydata, or a used equipment broker. If you can tell me what machine type you are looking at, then I can tell you what to look for. (MY-series, or TP series) Most important things right off the bat: *Machi
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Thu Mar 08 18:32:06 EST 2007 | stepheniii
You mean the only machine other than Mydata. I've run jobs where not all the feeders would fit. On Panasonic I needed two programs and non-intelligent feeder swaps. On Mydata push the button on the feeder magazine and pull it out and then put in the
Electronics Forum | Thu Mar 10 10:35:39 EST 2022 | paddymanoj
I have a used MYDATA Pick & Place Machine. It is MY9 and year 2000 Model (almost 22 years old). I have 5 extra magazines of this Machine (MY9). I want to know, if I can use these Magazines with any other latest MYDATA model. If someone can tell me, w
Electronics Forum | Wed Jun 28 18:05:13 EDT 2006 | Travis Eklund
I don't know about the TM8FC magazines but the Agilis magazines allow you to slow down the tape advancement speed. If you can, slow down the tape advancement on the TM8FC.
Electronics Forum | Thu Mar 10 19:35:44 EST 2022 | SMTA-64387687
All Mydata magazines should be compatible with the newer machines.
winsouce.jpg)
