Electronics Forum | Thu Aug 06 15:58:20 EDT 2015 | r92024
I'm looking for advice, please, concerning PSB ’s. I’m a complete newbie and not very technically minded, sorry! I manufacture and sell wall clocks that have a swinging pendulum. The pendulum mechanisms are made overseas and designed for the pendulu
Electronics Forum | Fri Jul 04 19:39:08 EDT 2003 | AlCapone
i'm newbie to this forum, I have a question about Cp and Cpk, nowaday, what number of ppm your company targets. Also as a SMT engineering you guys operate the whole smt line from SPM to ICT, has your company let you calculate the Cp and Cpk or there
Electronics Forum | Sun Dec 14 03:45:36 EST 2008 | fastek
You still have the same problem........who is going to train you and support it when it needs service? The end user you bought it from? Even the manufacturer will probably not support you if you purchased a used machine without paying them a registra
Electronics Forum | Fri Dec 22 21:36:22 EST 2017 | berrykane
Hello guys, Greetings to all! I am newbie here. I am looking for Reliable Assembly Manufacturer. I searched a little bit and found this site https://www.wellpcb.com/pcb-assembly-capabilities.html Did anyone try this one earlier? Please let me know
Electronics Forum | Tue Jan 21 16:11:05 EST 2020 | dgiordano
3.3.5.1 HIC Placement states "The HIC may be placed anywhere in the MBB, but should not be placed under, on top or touching a desiccant pouch." How do you assure that the HIC doesn't touch the desiccant pouch? Do you secure the HIC to the reel or to
Electronics Forum | Wed May 17 20:51:34 EDT 2000 | Dave F
Janet: What a great adventure you're starting!!!! For newbies: * Buy Ray Prasad's "Surface Mount Technology" book. * Attend RP's introductory course at NEPCON (or where ever) it's as good as anyone's. * Subscribe to "SMT" and "Circuits Assembly"
Electronics Forum | Wed May 17 13:00:52 EDT 2000 | Mike F
I just wanted to add a comment to the newbies, that dross must be recycled or it is considered a hazardous waste by the EPA. If you recycle it you can avoid a lot of documentation requirements needed for hazardous wastes, but you still need to have d
Electronics Forum | Thu Oct 07 04:29:40 EDT 1999 | Dylan T. Kenny
Hi all. I have some experiance in regular electronics, but the hardest part for me was always the soldering, so I am very intrested in SMT. So what would be the best way to get started in SMT? I would prefer not to have to spend alot of money, but
Electronics Forum | Thu May 07 17:50:41 EDT 2009 | ecad
Hi, I'm a newbie here but I've lurked about this forum in the past! I'm an experienced PCB Designer I've found myself out of work due to the economy so I'm attempting to start out as a freelancer, I've found that more than a few of the smaller R&D fi
Electronics Forum | Wed Jul 29 03:32:57 EDT 2009 | dilogic
We recently started to use wave-soldering. As total newbies in that field, we got successful results most of the time. Howewer, this batch of PCB's had a lot of resdiue, as shown on the picture. Most of it is most likely flux, but on some areas even
