Electronics Forum | Mon Dec 11 20:49:47 EST 2006 | davef
When we hear "optimizing", we think design of experiments
Electronics Forum | Sun Aug 22 17:12:55 EDT 2004 | Mark Hugill
Hi All I would like to know if there is software available to optimize placement files for Samsung machines. We are currently using the on-line software off-line but combine setups and just plain ordinary setups and optimization are painfully slow.
Electronics Forum | Thu May 11 01:30:27 EDT 2006 | pavel_murtishev
Good morning, FYI, it's better to set "relative" instead of "teaching" for tape feeders. In this case optimizer will have an opportunity to change feeder position during program optimization. "Teaching" will fix feeder position and optimizer will ne
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
Electronics Forum | Mon Jan 15 04:54:57 EST 2001 | mattias
Here�s my opinion PanaPro (Panasonic): good balancing/optimization, very easy to setup and use, quick good results, not so good support for third party machines(optimization), Timestamps for balancing/optimization is quite accurate. Cad-conversion?
Electronics Forum | Sun Apr 30 22:29:23 EDT 2000 | Jack
We use Fujicam for FUJI CP643 programming and optimizing in our plant. There are about 800 parts (80% chips and 20% lead components) being placeed by 2 CP643. When using Fujicam automaticly allocate feeders and optimize insert order, I got 29000 cph
Electronics Forum | Tue Dec 21 22:35:55 EST 1999 | Dave F
Paul: Assuming you don't want to buy more feeders, take one of these two angles: 1 Philips markets line optimization software. 2 Independant CAD/CAM sofware suppliers (ie, aegis, gencam) sell line optimizers. The names of such folk are in the arch
Electronics Forum | Fri Apr 07 17:44:17 EDT 2006 | bobpan
You can either optimize both boards from the very start to the same table top or you can assign the feeders under configure tabletop to the same spot that they were in when you optimized the first program. Remember that you can optimize many differen
Electronics Forum | Sun May 28 23:01:31 EDT 2006 | jacksaria
Hello to all, We are encountered many problems/defects in SMT lines.I would like to know your suggestion or recommendation for SMT optimization and improvement. What are the step by step solutions in order to optimized and to improve the printer, pi
Electronics Forum | Mon Aug 20 13:45:12 EDT 2007 | brulal1
We are low volume high mix, when we program the pick and place equipment we like to program and optimize several different PCB on the same set-up. We used to work with Panapro form Panasonic. I have and MSR, MPA 3F and Universal Advantis AX-72. Looki
.gif)
